I bid 90.00
Type: Posts; User: billyb
when you close the mold, do not hold the sprue handle, it will cause a gap and cause flashing.
Forum: Gunsmithing Tips & Tricks
Try using a shop vac to draw the glue into the crack. It works.
Forum: Rimfire Area
I found a hand full of unfired 22 rimfire with "22" as the head stamp. Any one know the maker of this ammo?
Forum: Completed Deals
I will take the 38 super brass. PM sent
Forum: Gas Checks
Have you tried flaring the gas check before seating? Looks like the lip of the check is hanging up on the die as you insert the bullet nose first into the die. Looks like base first is the way to go.
Forum: Casting Equipment
It is worn. There is a lot of play in the ram. Check out Buckshot method of drilling and taping the collar for adjusting screws.
Forum: Cast Boolits
Running my clubs indoor range I find a lot of factory ammo with primers that look like the one you found. Oversize firing pin hole allows brass to flow around the firing pin and gets wiped off on...
Forum: Special Projects
Think funnel shape, very slight taper. Bill
Forum: Casting Equipment
I would try to call Lyman customer service and try to get the right part. Is your old pressure screw still good?
Forum: Completed Deals
Lee 452-200 RNFP & 452-255 RNFP 6 cavity molds $75.00 for the pair shipped. SPF
Lee 452-200 SWC & 452-228 RN 6 cavity molds $75.00 for the pair shipped SPF
...
Forum: Completed Deals
I have a RCBS 124 grain RNTG two cavity. Excellent condition You can see the mold at midway. $55.00 shipped. Let me know!
Forum: Casting Equipment
First picture, the 4 pieces are lee decaping bases. Last picture is the drum and adjusting stem for RCBS powder measure-Uniflow.
Forum: Casting Equipment
I removed the bad element from mine. I drew a line across the top of the plate using a square and the center of the wire. Clamped in the drill press vise and marked the center of the edge. I drilled...
Forum: Swaging
I use dawn dish soap to degrease then wet tumble in my STM tumbler. They shine like gold.
Forum: Casting Equipment
Remove the jam nut on the bottom of the threaded guide rod and run the threaded guide up until flush with the casting. Harder for me to try to explain than it is do. See if this will get you the...
Forum: Reloading Equipment
This is the cap for the lube reservoir on the Lyman bullet sizer luber.
We bought new recliners.. We are working on year 54 married, after dating for two years.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |