Search:

I will have shoot mine for a group to see. At 25 yards they are all touching, that’s the furthest I have shot it with a target. Mostly I shoot steel out to about 75 yds

Or you could go with a RDB system that CMMG developed and no more lead on the tail of the bolt

Reloading press sold to Rockindaddy

I shoot at a private club with over 1000 members, they are strict there and will kick you out if you violate the rules or give one of the range masters a hard time.

I have no problems with that...

Old RCBS press with primer attachment $75 plus shipping Not rusty just old
320154


Lyman 450 lubesizer with homemade die nut and heater $75 plus shipping320153

I have the Lyman 314299 bullet which is an excellent boolit do you want any?

What are you using for a magazine? Many of those wildcats are cool but for me getting them to run through a magazine was the problem.

Would like to buy a 30 cal light weight gascheck mold 130-150 gr any number of cavities. needs to be pointed or RN to work in an AR

I use the NOE 357-190-RF-06. Works well in the AR

The Lyman 314299 makes a good subsonic round. No issues with feeding either

PM sent to Fitz

RCBS mold sold to Wadsworth pending $

Honestly I dont know never used it Let me cast some with it and get back to you

Starline brass 100 pieces maybe 5 fired 1x rest are unused
When its instock it sells for .60 cents each if you buy 1000 $sold to Fitz
http://i.imgur.com/f8pjesP.jpg

accurate molds 40 cal 4...

Thanks everyone

I am pulling all my 300 Black loads and starting over with AA#9 data, whats interesting is I have used it in other catridges with H110 data with no issues. 44 mag, 38-55

The...

I recently started loading for 300 Black with surplus wc820

Im using H110 data with Lee 180 and Lee 160 gr

I am using 18 grains with the Lee 160 gr and 15 gr with Lee 180

I am getting blown...

Like others have said, I would get leading around the tail of the bolt. Powder coating is kind of a PITA but if its setup right its much faster than convetional lubing

The inside looks ok, I will push a soft lead slug down it to test

284405
284406
284407

I tig welded a small block to the barrel and bent a piece of metal around the front of the forend and the screwed the sheet metal band to the block

I powder coated the...

Its also not a low number, Remington never made any with heat treat problems.

Original finish was dipping the rifle in oil when hot (not sure what oil was used)

I have had nothing but problems getting the 300blk to chamber in the ar with cast also had issues with the 30 hrt (a rimless 30 herrett made from 6.8 spc cases)

I finally gave up on 30 cal cast in...

I wasn’t concerned about squeezing all the lead out. I assumed you wanted it out to get the best price from the scrapyard. Lead contaminated copper doesn’t bring as much $$

Did you get all the lead out of it. I reheated my jackets and dumped them out on a screen, got another pound of lead out of them I need to clean mine but I only have about 2 pounds.

I cut a shower pan up with a hatchet, try cutting or chopping first sawing gets lead chunks everywhere. Hammer and wedge is good idea too