Search:

The bubbling of the coating was because ALL of the acetone had not evaporated. Its surprising how long it takes for it all to get out of lead pores

About 1600 to 1700 fairly easily
Somewhere around 1900 to 2000 fps you will loose accuracy and need a check
Every gun is different as are powder/ primer/ bullet match

Ral is an industry standard color code.
So any mfg can ,if they want to, mfg a particular color it will match the same color.

The MFG can call it whatever color they want but as long as the RAL...

Will do.
I want to do a few more batches throwing in a couple variables before I declare a winner and get a batch ordered.
Just like to be absolutely sure powder works like it's supposed to...

Sorry but no... not where my powder comes from

OK got some preliminary sample of 2 colors in the running to replace Traffic Purple
did a quick and dirty hard core test batch of each to see worst case scenario coating capability
NO BB's, approx...

adding gas checks would be very helpful in your pursuits

To confirm the above answers yes the PC will absorb moisture and that will kill the ability to create static.
Store ONLY in air tight containers.
Screw Type with a gasket is good

used to hunt where typical shots were 150 to 500 yds .. Most were 200 Plus . At those ranges I preferred Jacketed bullets for the better accuracy.
Now where I hunt 50 to 100 yds is average so Cast...

Usually 1 of 2 things
1. did not cure at an actual 400 degrees or for long enough at 400 degrees
2. bullets slightly undersized for bore

I shoot exclusively PC's bullets in my CVA Optima 50 cal rifle. Very very accurately.
Kill at least 2 deer a year with.
been doing so fore about 8 years now

I will say almost every PC customer I have shooting 9MM are sizing to 357 or even 358 to get them to shoot properly
If your chamber will not take bullets sized over .3560 you probably only have 2...

I would say yes.. Its like this there is NO issue with cooking longer as long as you oven maintains a fairly consistent 400 degrees. The problem comes in when you have wild swings in temps especially...

leading with pc indicates powder not properly cured .. correct Time and Temp are critical to good pc coating without leading
an actual oven temp of 400 degrees for 20 minutes min on small bullets. ...

I have several customer who use paintball guns to run off Geese. They say it works well

Spray them with Dawn degeeser

1977 started with a wack a mole 30-06 lee handloader and rubber mallet sitting on the porch steps of a duplex in the swamps of eastern NC.
couple years later graduated to a house in Charlotte NC...

Silica Gel packs work well. Put them in with the powder seal shut for a few days.
Pull the silica gel packs out and stick in oven on 140-1540 degrees and you can dry them out and reuse

At 2100 FPS you are reaching the limit of PC accuracy without a check installed .
I would try again with a check and would bet you see better accuracy

Prayers will be sent for him

yes I would expect you had some PC adhere to the walls with that much at one time :)
That much PC cant just float to the top. A little too thick its going to go somewhere.
I usually put 100 to...

from the fairly vague description it could be for a 1919 belt fed

I would call JES. I believe in Oregon. http://35caliber.com
Reboring is his specialty
He did a 308 to 358 for me and if shoots wonderfully.

#12 will work fine in short distance for snakes.

Good move . saves a lot of hassle