Search:

Your lucky in Ontario Canada we are paying $48 for a deer tag

the local security company rents our range and after they left I found 2 cases 00 buckshot , a case and a half of 40 S&W and 3 holsters loaded them up took them home called them up they sent one of...

welcome aboard

try a hard ware store in the pluming section the solder you get at radio shack is made for soldering wire and is acid core.

let me guess there is about 37 holes in the stock for sling mounts LOL

I would be concerned about the aluminum rivits holding the handle on being strong enough for moving the pot around with it being full of lead. A accident waiting to happen

I soak my mould handles in a can of linseed oil about once a year it keeps them tight swells the wood tight to the metal

My cat steals it off the reloading bench so much fun to step on in the middle of the night

I find for paper wasp it is best to wait till dark when they all have returned to the nest then light the thing up with my propane torch you get a big ball of flame but ya get them all

what is the over all bullet length that you are using for the 223 with the Bator I can't find load data for it.

don't over look key fobs when looking for pewter a friend worked in a trophy shop they csat thousands of key fobs out of pewter for golf turnenments and business perks they weren't marked as pewter ...

drill a hole at the end of the crack so it won't crack further then v grind the crack out the heat the crack area with a cutting torch till all most red hot then weld leaving the drilled hole to weld...

If they are falling out of the mould ok the need to polish is not there I have only had to polish a couple of my moulds

the Wife cleans the car and claims that every cup holder and storage compartment contains brass and then says its not even in calibers that you shoot lol . The reply is that it's for my bud when I...

you might want to read the sticky about lee menting your mould and the the one about mould lube before you start casting it may save you some grief

friend of mine use to work at a trophy shop and they cast loads of key fobs out of pewter so when I go to the good will I look though the bin of key fobs or some times you can pick up a belt buckle...

I'm using the lee .314 to size and seat the gas checks using LLA

2 inch groups at a hundred yards if I do my part . but I'm thinking a little more powder would tighten it up a bit I have been playing with seating depth the last few trips to the range but its not...

I use 22.5 grains of 4198 with this boolit for my mosin and my enfield

Mine runs 52 grains right out of the mould have not gas checked any yet so I can't tell you the finished weight. but I would like to know what some of you guys a running for over all cartridge ...

I use LLA but warm up the bullets in a toaster oven just warm to touch so they coat evenly and use less lube then seat the gas check then repeat the lube process

Coleman and cast iron pot does it for me too. Less than 10 buck invested been working for years and it melts quicker than a electric pot.

Did the wheel weights come from that there Christine car LOL

Has any one tryed just dumping a bunch of glue sticks in their bottom pore lead pot you would have lots of heat and lots of flow and when run dry i don't think it would bother the next pot of lead...

You might try useing a felt bore button under your sabot loaded down with bore butter because sabots are not desined to use lube so we you load you loose all the lube going in and and the sabot...