MidSouth Shooters SupplyRepackboxSnyders JerkyRotoMetals2
Load DataReloading EverythingInline FabricationLee Precision
Wideners Titan Reloading

Search:

Type: Posts; User: Lightning Ross

Page 1 of 4 1 2 3 4
Results 1 to 25 of 78

Search: Search took 0.00 seconds.

  1. Many years ago in the coast range of Oregon. Our...

    Many years ago in the coast range of Oregon. Our local game warden.Ex WW2 vet. Stopped by and said old granny down the rd needed some meat. So if I found a good road kill drop it off to her. We...
  2. Replies
    26
    Views
    4,377

    I have an old 3006 Smith and Wesson 1500 made by...

    I have an old 3006 Smith and Wesson 1500 made by Howa has killed everything I shot it at. 180 grain Noslers has killed a truckload of deer and 6 elk..A 130 grain Speer hollow point with 4350 powder...
  3. Forum: Our Town

    Poll: I was following a pickup down the highway It...

    I was following a pickup down the highway It looked like they were moving. They had a big dresser in the bed of the truck. The top dresser drawer kept opening wider as they bounced down the road. All...
  4. Thread: 35 rem

    by Lightning Ross
    Replies
    16
    Views
    3,039

    Forum: Leverguns

    I have not seen any pistol powders in my area for...

    I have not seen any pistol powders in my area for over 2 years Unique red dot green dot 2400 nada no way zilch. Had to switch over to blackpowder for my 45 long colts.
  5. Thread: 35 rem

    by Lightning Ross
    Replies
    16
    Views
    3,039

    Forum: Leverguns

    I have h4895, h380, and can get my hands on some...

    I have h4895, h380, and can get my hands on some 3031 powder in SE AZ is purty scarce. 20 inch barrel made in 1952
  6. Thread: 35 rem

    by Lightning Ross
    Replies
    16
    Views
    3,039

    Forum: Leverguns

    35 rem

    I just got my rcbs 200 mold. Fired up the pot after about 5 cycles it was making wonderful bullets. Without making anyone responsible for their pet loads for this combo is there an official load data...
  7. Replies
    1
    Views
    563

    Forum: Leverguns

    RCBS 200 grain for 35 rem

    www.bullets .com has a close out on 200 grain fn rcbs mold for the 35 rem 57 bucks plus shipping Mines on its way. Just for your info. Go to reloading then to casting section
  8. Replies
    509
    Views
    96,017

    Forum: Cast Boolits

    I shot a not a very good friends 8mm mag once...

    I shot a not a very good friends 8mm mag once left snot boogers hanging out in mid air. I got back at him . We set a can behind a small tree and I said My savage 99 308 would shoot through the tree...
  9. Replies
    5
    Views
    1,471

    Uzi is what you said made in Israel 9mm 3o round...

    Uzi is what you said made in Israel 9mm 3o round mag I beleive. Will be going back later this week to take pictures.
  10. Replies
    5
    Views
    1,471

    reminton a303 and uzzi

    i have a neighbor that lost her dad at age 89 she has asked me to help sell a few of her dads guns. One is a remington 03a3 .Pristine orignal condition I have seen on auction websigts 650 to 1200...
  11. Replies
    42
    Views
    8,042

    No sir they were not.Imediate Destruction of the...

    No sir they were not.Imediate Destruction of the the birds were ordered by the state vet. The sheriff was called in on the complaint was referred to the state vet. After the sherriff consultated with...
  12. Replies
    42
    Views
    8,042

    If you have to dispatch a large amount of small...

    If you have to dispatch a large amount of small animals. A heavy duty wood chipper works quite well. 18,000 chickens with some internal parasite that made them uneatable. It was a write up in ag...
  13. Replies
    10
    Views
    3,717

    About 85 miles to the nearest hobby shop I think...

    About 85 miles to the nearest hobby shop I think I will opt for the spring kit and Us postal service. for 15 bucks.
  14. Replies
    10
    Views
    3,717

    I have not seen a breakdown of the innerds of...

    I have not seen a breakdown of the innerds of this gun.And I dang sure there isnt any music wire available for probably a100 miles or so. Further reserch will be needed.
  15. Replies
    10
    Views
    3,717

    I had fire formed 5 cases loaded five cases with...

    I had fire formed 5 cases loaded five cases with 10 grains of unique behind a lead cast bullet that weighed 170 with lube and gas check. I shot a three inch group at 50 yards . Not to bad for having...
  16. Replies
    10
    Views
    3,717

    7mm roling block.

    I have a 7mm rolling block short carbine with saddle ring . It has Uruguay mark on the stock. Very tight strong sharp edges on hammer , block and very deep excellent riffling.I have shot 5 rounds of...
  17. Replies
    31
    Views
    8,349

    Forum: Our Town

    We had gopher guns. Metal plate galvanized pipe...

    We had gopher guns. Metal plate galvanized pipe that would fit a 12 gauge with a cap. Drill hole in the cap a nail and a trigger set up. With a trip wire out front. Dig out the gopher hole place the...
  18. Replies
    14
    Views
    2,377

    Forum: Cast Boolits

    Good Idea will shoot the rest out of my 06. I new...

    Good Idea will shoot the rest out of my 06. I new there would be some wizards on here.
  19. Replies
    14
    Views
    2,377

    Forum: Cast Boolits

    Thanks for the info will look for something else

    Thanks for the info will look for something else
  20. Replies
    14
    Views
    2,377

    Forum: Cast Boolits

    brass bullet

    Gentlemen. I put forth my idea of a Christmas gift to someone who might have done this before I would like to make my dad a thirty caliber brass bullet for his key chain. I have a thirty cal mold ...
  21. Forum: Leverguns

    Best shot I made I had flat fields all around my...

    Best shot I made I had flat fields all around my place when I lived in Oregon. I saw a coyote coming down the fence line. He stopped and sat down right in front of a railroad tie corner post. Grabbed...
  22. Replies
    71
    Views
    30,681

    Forum: Leverguns

    A Winchester trapper in 44mag with a 300 grain...

    A Winchester trapper in 44mag with a 300 grain boolit at max will make you have to start over your shooting training to get rid of your flinching problem. It will flip a 2 ft square 1/2 inch steel...
  23. Replies
    19
    Views
    4,050

    Yep I flunked rockstar, and superhero only thing...

    Yep I flunked rockstar, and superhero only thing left on my aptitude test was horseshoer or proctoligist. My fingers are short and stuby went with horseshoeing.
  24. Replies
    19
    Views
    4,050

    Event center Fizz bomb classic 2000. St croix...

    Event center Fizz bomb classic 2000. St croix rims all the way around on High hocked running horses that need traction when they dont get up under them selves very well.Rims on front plains on rears...
  25. Replies
    19
    Views
    4,050

    You guys that shoe and live in Montana and...

    You guys that shoe and live in Montana and Wyoming must have barbwire for hair on your chests. Shod some barrel horses at a big barrel race in Gillet (may not have spelled that right). one time...
Results 1 to 25 of 78
Page 1 of 4 1 2 3 4
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check