Search:

That is Bill Ackermans shop. His daughter is doing the work now . I have had 2 Weaver T series scopes cleaned / tuned by her . Great service and reasonable service time . Barry

That looks very familiar .

Name of company making 32/40 is Load X in N. CA . hope this helps .

Anybody had any contact with Ron at Octopus Solutions ? I have gotten calls from them . tia bwgdog

Ted Brown Rifles in Oregon. Have had Ted do my gas gun work for the past thirty years without any problems. Barry

Thank You Al-Great turn around time on this mold being made---

If you are close to Sacramento I have isotope lead that you could use as is for handgun-I am in need of some soft for breech seated bullets. Welcome to the Forum!

I am in Sacramento. I send my bolt gun work to GAP in Kansas-Send my gas gun work to Ted Brown in Oregon-Send my SS work to CPA in PA. You might check over on the SS forum as there are fellows that...

Eric hollow point-Has done a few for me-great work and turnaround.

Roto Metals-site sponser-top of page.

Swede- Any hope that in the future we could see some of the popular molds done in iron ? tia

Make sure you keep a lid on the pot-keeps heat in the pot-gets all the lead out of the jackets.

Would like to see Al-NOE-make both the 332/334 with correct specs the two molds I have are both out of spec.

PS-Could you tell us the name of the company that the molds are being outsourced to ? tia

Master Pot with PID-soooo nice !!!!

$ 6.38 from Titan. Best tool made by Lee!

There is also the saga of the 7mm THOR from BC. If the remake is made-it might be a keeper. Time will tell.

I have spoken to them at Criterion - are in development-would not hurt to call them and show interest-Also checked on importing some from AU but end cost for a GOOD new made barrel with all the fees...

I have same unit as Rick-It is a great piece of equipment.

Guardian-The first thing that I noticed when I received my Magma w/pid installed was the quality of the materials used. It works. Very well made unit.

Went with 120v and went with the installed PID-am VERY glad that I purchased it. Product is well made-with quality materials-and people that will answer questions if you have to phone them. Have had...

I bought two of the 2.5 lb four cavity molds from Brandon Foundry when he made the first batch for the CB Forum. Great molds + the ingots fit in small flat rate box for shipping. I only do 200 lbs at...

Dragon-That one is the ONLY mold -custom-that I have had real challenges with-But-the 3 cav hp-same bullet works fine???

I have a Bench Source-Great unit-great cust service. Very happy with it.

Al does supply the oil-all you have to do is look at the page when you order your mold and clink on the box where it shows lube/or the other if you want set of allen wrenches with your mold. His...