Search:

I bought a late manufactured '94 in 38-55 BB. I call it a BB since the groove diameter was .3805". that was bad enough, but to make matters worse the chamber was minimum sized, or less. The smallest...

Geargnasher has it - sawzall with a demolition blade and a tarp or 5 gallon bucket to catch the chips.

Zinc, maybe

Go to Radio shack and purchase two microphone extensions cords. The ends should be the same as the cords on the sensors. Open the sensors and replace the cords. You'll need a low wattage, 15 w...

I shoot a Marlin in 32 H&R in Pistol Cartridge Cowboy Lever Action Silhouette using the Lyman 311419 sized .313" over 6.3 grs. of AA #7. Shoots 2" or better at 100m off bags, which is a far cry...

djoiner is right on - Get a couple of Thermacells. We use them for spring turkey hunting - keeps the mosquitoes at bay.

Try this site.

http://www.onlinemetals.com/

Look up the Greenhill formula.

Do you have to shoot left hand cast boolits in a left hand twist barrell?

Lap the crown.
Loosen the forearm and mag tube, rearrangealittle and tighten back up.
Split an O ring and put it between the barrel and foreend and move it up and down the barrel and test groups at...

Ditto the Hornet for Hunter's Pistol Silhouette.
Like Canyon-ghost I use the taco hold and shoot at 22 mag velocity w a 52 gr. boolit

Call Marble Arms. I have 2 of the improved versions and 2 of the originals and they all work great. Surely they will make it right.

I wipe the base of bullets on a paper towel on by bench. most lubes on the base of bullets will contaminate the powder that contacts it, especially alox, remove it from the base. the contaminated...

Use practice/sighting targets the same size, shape and color as the match targets you will be shooting. You will become more accostomed to the site picture.

I'm using the 90 gr Lyman 311419 sized .313 in fron of No. 7 with very good results in Pistol Cartridge Cowboy Lever Action Rifle Silhouette. PM mey your address and I'll send you a few with my load...

Try Dave Manson

http://www.mansonreamers.com/

If you are taper crimping, and should be, back off a little on the crimp die. Too much crimp will swage the boolit down.

If the primer pockest are noticably loose I'd suggest trashing the brass. Hopefully you'll be wearing safety glasses when you blow a primer and gloves too if you're shooting a revolver.
Been there -...

Back to the accuracy problem - Your load is transonic at 200 yds. You need to adjust the load up or down to make it supersonic or subsonic all the way out. With your barrel twist I believe that I...

If you "can see strips of lead hanging down", your bullets must be undersized.
Have you slugged the bore? If so, are you sizing the boolits .001 or so over groove diameter?
Be careful not to over...

As of 2:00 p.m. CDT, 7/14/09, Widener's has Wolf Primers

You should have a Big Bore 375 - I do. It's one heck of a deer stopper.

Here is a photo of a T/C 357 MAG chamber cast with a 357 Mag and 357 Max case for comparison. Note that the extremely long throat will still be long for the Max. That's a 170 gr Nosler set out in the...

Rapine molds are good quality good casting molds - I have 3 or 4 of them

I've had good luck with the Lyman 225215. You probably don't want to try to push a cast boolit too fast through the 1:9 twist.