Search:

I would install a lawn sprinkler system activated by a motion sensor. That would dampen their spirits.

I'll take #8, the 357 brass. PM inbound.

The chart on the Wikipedia page on Shot has all the sizes of shot including dust. https://en.wikipedia.org/wiki/Shot_(pellet) #12 and dust are different sizes.

In the old days, Oil finish meant that the product was absorbed into the pores of the wood and hardened. Paint thinner or turpintine was used as a thinner. Popular products were linseed oil and...

Lead gloves is a generic term for protective gloves worn by X-ray technicians. In years past they did have lead. But considering the EPA stance on lead, The manufactures make them lead free now. ...

Loctite was never designed to be a thread sealer and will not work as one. It is a thread glue to resist or prevent the thread from becoming unscrewed.

I find that reloading is a separate hobby from shooting. It involves a different skill set and different equipment. Don't get me wrong, I enjoy reloading. If I had to judge which hobby I enjoy...

Before lead shot was banned in many public areas, Lead dust could be bought. It was generally considered to be .048" or less. It is dangerous to inhale and for the environment. It will also coat...

Their website says that last Friday an electrical storm (lightening) put voltage spikes into the power system that damaged their servers. They will be back online shortly. With fried computer...

There is no 1, "the best powder" for all applications! Unique will work in the most applications but it can not be called the best.

I'll take #33, PM sent.

It seems as the previous owner of your Henry decided tp remain silent about his rifles issues and sell it rather than fix it. Henry gave me awesome service when I sent in my 3 month old Henry for...

Is #2 a single or double cavity? The photo shows it to be a single.

I have bought used molds from the members on this website and each and every one of them were just as they described and fully usable without any issues. 4 of them were steel molds that will last a...

The easy way to determine what B&M model you have is the length of the base the attaches to the bench. The Model 26 base is shorter and ends a few inches past the handle's link bolt. The Model 28...

Your friend need to look harder. Carcano stripper clips can be bought off of Ebay from numerous sellers, they are so common that amazon even carries them.

I have the newer Lyman American 8 and the older Lyman turret. The American 8 can be tighten up very easily to tight tolerances. Out of the box it was tight, but I tighten is up a bit more. I like...

Great tip James! Thanks

That's a good idea Hootmix. Unfortunately my press doesn't allow enough of the exposed bullet to be grabbed. I may have to take my neighbor, remy3424's suggestion and just hammer it out over a few...

A check on the Hornaby and RCSB collet pullers says they're not for lead bullets. The 2 presses I have are Lyman turret presses. I may have to risk carpel tunnel syndrome to extract these bullets...

I have been using a 3/8" steel plate on my concrete basement floor as the anvil. Usually 3 whacks is all it takes to unseat the bullet. But with something like over 200 cartridges to do, the...

I've acquired a significant amount of reloaded 44 mag that I want disassemble. There's got to be a better way to pull the bullets than using my kinetic (hammer) bullet puller. Any suggestions?

The exploding firearm could be caused by an overcharge of powder, to heavy of bullet, Oversized diameter of bullet, or a weak or defective firearm. With the primers rare and expensive, I would...

As mentioned before, a good rasp is mandatory for your grip project. Rough cut the wood to approximate size and start rasping away. I find a cardboard cutout of the size I want to grips to be very...

I would like #1. TL314-90-SWC $25
PM incoming.