Search:

Buddy..

Will 6 foot 5 get it done...? :-)
In all seriousness, i appreciate your response to my ad but I really am looking for a blued model.
Thanks...

I am looking for a Ruger Vaquero in 45 Colt. It Must be the early large frame model, 5.5 inch barrel, blued, in very good condition. Any help would be appreciated in locating this item.
Thanks...

Does anyone have any Sharpshooter molds they would like to sell?

Thank you but they only carry Lee and are out of stock. I am really looking for the Sharpshooter mold in .310 caliber.

Wanting to buy a .310 cal Sharpshooter buckshot mold in excellent condition. I would also consider purchasing other caliber Sharpshooter molds.
Thanks...

I know it's been a year since your post.. any updates, sucesses, failures?
Also, you stated that you got 1300 fps with published data.. is that data for a standard 2 3/4 length shell which you then...

Here is a link to the bottom pour pot I designed and built.

http://castboolits.gunloads.com/showthread.php?146065-New-bottom-pour-smelting-pot!

Shad

You don't run into any of those problems when using a "Shad Style" Bottom pour Spout and pot.



Most of those valves have plastic or teflon in them.. It won't work

Shad

If you have to be ready to catch over flow due to problems.. Then I think there is a flaw in the design.

Shad

Even with a bottom pour pot (I built a 400 pounder) you are still going to have skim and flux. I found that a metal ice fishing ladle for clearing the ice works excellent. My ladle has 1/4 inch...

Wow.. nice work! Using hot water is a big plus in the cooling dept. The fact that the ramp is below the water line amazes me. How far below? The shot must stay soft/hot enough to roll down the...

+1
14$ a pound.. Where? I would buy 10 pounds if at that price.

I have not tried pellets so I can't say, but for me, I find the best use for BP substitutes is in a break open shotgun. Load'm...

Good info! Thanks..

Shad

Generally WW's are a bit too hard for maxi balls. Try something softer closer to pure lead. WW's do work well for patched round balls though.

Shad

Cast iron Corn wedge pans stack the same.. 1 in then 1 out, and come in at just over 2 pounds each.

Shad

Regular muffin tins are a pain.. Not my idea of a good time. I'll chime in with the others on using cast iron, they fall out every time with no muss, no fuss.

Shad

I agree here.. Very seldom do I have to add anything to my range scrap. If I do it is a very small amount for long skinny boolits.

Shad

+1

Shad

166 degrees F is not a very big window, and if not paying attention, going over happens quickly.

Shad

You can control the temp of any pot/melt with an attentive eye and a thermometer.

Shad

I couldn't have said it better myself! :)

Shad

It sounds like a lot of work and could be a safety hazard if not done correctly. I run 2 Lee pro 4-20's side by side. Fill them both with ingots and help one of them heat up with a propane torch...

When it comes to smelting/rendering scrap lead, especially in large batches... a propane burner, a thermometer, and a large cast iron or heavy welded steel pot is really hard to beat. The...

If you use only 1 pot, make sure you clean it very thoroughly between every smelting and casting session. If not, you will end up with dirt and junk in your boolits.

Shad

where is the link?