Search:

I heard it was used as a lube cookie in the big guns they punched out 2 discs from each flat.
I got about 800 pounds of it still i need to get rid of , setting in the shop

I got some of shilohs new stuff it works good. Most anything with water in it is good as long as you oil it afterwards.

Oh buckshot the only way that I found to put it on evenly was to put a half a drop on your finger wet both sides of the patch and pull it till it was semi dry if you put it on any thicker than that...

I did a little but the cases I made from 45-70s all tore apart at the shoulder , it didnt do it with mokeless

we had some of that ,factory loaded and we split most of them. they split in the head across the primer, I was not impressed with the stuff.

That was Elmer Keiths load for the 50-3&1/4 sharps p

Anyone been getting their backorders from this guy?

Making 4050 bottlenecks is the same way if you Aneal them they get too soft and they get mushy

Maybe fire them before you.trim they may come out right especially if you shoot them greaser sized patched ones :-)

I have both. Drop me a pm and we can talk about it

I have one with a tight chamber and a slow twist barrel 1-18, I also use the kal bullet exclusively

both the 265 and 285 gn bullets work as well as anything and I am really happy with what it...

a lid lifter for a wood stove ,,?

I used a threaded sling swivel

look hard at the muzzle crown.

I bought a mould from turboman he was promt , kept me informed of shipping and ,packaged the mould good enough that the po couldnt do any damage to it , truly a good guy to deal with , thank you

you can either loose fill the case and compress the 1/2 inch or you can drop the powder through a long tube and only have to compress it a 1/4 inch or less, compression is a real arbitrary thing...

I cast at 745 for the soft alloys and for the 40s use a faster cadence than with the bigger 44s and 45s

cast it soft as is , with 2 tho paper fill a case to the brim with black powder compress 1/2 inch put a 30 tho wad on top a 3/16 layer of good bp lube ,another card wad and set the bullet on top ,...

it was definitely done years go..I had to cut off 11 inches of barrel before the bore was truely visible as a bore, it really was junk and the cleaner I got it the worse it got , . I should have left...

Powderburner - on your chamber, could you see any rings or anything inside the chamber to indicate a bad chamber? Interesting they would have cut the 50-70 brass short.... I'll bet they were wanting...

I do not have a specific measurement but had an old roller with a 50-70 chamber that broke brass right at your numbers ,I pretty much figured it was used extensively with the short ammo and they...

the postel bullet was the premier bullet for many years for target shooting , the round nose will work just as well but will take a little more elevation, either one will do the job quite well with...

throw in a pair of chains and a good snow shovel.

It's good the parts are available , I was told that they quit making the sight. Hope it was misinformation.

which company BAco or smith enterprises? please..