Search:

Measure one of the marked ones to see what spring back should be.

It's a Lee aluminum mold. Mine drops 172gr. .267"

I picked up a sporterized Swede recently at the local gun show. This spring's project will be getting a good cast load for it. I picked up the cruise missile mold, and have been searching for...

I don't see that bullet in the Lee manual. There's a 100 gr boolit listed, but not the 105.

I have a Rossi in 45 Colt. It was OK new, but I bought the DVD from Steve's Gunz.
I followed his instructions in the DVD, and replaced the ejector spring. Made a huge difference. Now it's the one...

Got one about 6 months ago. Shoots OK. Haven't had any failures yet, with factory ammo or handloads.Shoots the LEE 102 gr cast well.
Nice carry pistol, easier to conceal than my bulldog!

I run 6.6gr Unique with the Lee 215gr SWC. Works good in my Bulldog. Just got the Lee 200gr RNFP, but haven't tried it yet. I'm on the group buy list for the 200gr HP. Can't wait to see how that one...

I'm using the Lee 356-102-1R over 2.6 grains of HP-38. Pretty mild plinking load.It cycles fine & doesn't fling the brass very far.
I've shot about 250 rounds so far, & haven't had any failures of...

I used it in my 44 Special. Works well for light loads. I like the way it fills the case, to help reduce the risk of a double charge.

Midway has the shellholders.

I use the Lee 2 cav 102gr mold in my TCP. 2.8 gr HP-38. Had to run OAL a little short to function properly. Keeps all shots on a paper plate@ 20'.

I've got a newer Bulldog Pug. Shoots well, no problems so far.

Bulldog fun:D

I use LLA on my .38Spl with good results. Didn't have much luck with anything else. Bad leading on the .357 Mag & .303 Brit. Switched to Carnuba Red on those.

I've had good luck with the Pro. Double disc works, but i haven't had good results with the adjustable charge bar.

CR works great in everything I shoot. (38/357, 303, 44spl) I use it in everything because it works well, is inexpensive, & I'm too lazy to clean out the lubesizer when I change boolits.

It worked fine in 38/357. I use carnuba red now, but wouldn't hesitate to use orange magic again if I got a good deal on it.

Mine drops around .360. OAL is 1.432.

H4895 works well in my 303 with cast.

I had the same problem when sized to .358. Sized to .359 & the leading went away.

Ooops, make that PB .432

I'm in. .434 pb

What would the cost be for a PB 2cav? Looks like just the ticket for my bulldog!

What's the best wat to cut out the bevel??

I had the same problem. Lee 158RF, LLA .38 brass. Bought A lyman 4500 & lubed with orange magic. Same size boolit, no leading. Waiting for Lar's carnuba red to arrive, & see how that works.