Search:

Hi ive currently machined a fat bastard style muzzle brake. Its 3 inches long with 6 slots milled into it at 65 degrees. (Three on each side 180*). Now three of them are spaced .250 apart and are...

Pretty sure they were they could of been fired out of a rotary gun too

Ive got a few of them too and they are off about a 1/8 inch from being square to the case wall..

Im gunna try that. If that doesnt work any idea?

Hi im trying to figure out if i can save some casing ive got. The 50mbg casings are crooked as a jay bird at the rim and am trying to figure out how to straighten them.
They are once fired military...

That be the one if you could please contact your friend that be awesome! Thanks then jus pm me back once you find out what he says.

This gun is from ww2 the 37 mm anti tank gun used smokeless back in the war they didnt have only but a little bp to boost flame during ignition. The main charge was 4ounces of large grained smokeless...

Firing projectiles he was looking for smokeless

Hi im trying to find a source for large bore cannon powder. I cant find any super slow
Or similar powder. Im trying to help a buddy of mine out that has a 37mm at gun. Hope someone can help me...

Ur right i was looking at something different. My fault.

I see noe carries the replacement die body that be the one i need when they get back in stock correct? Along with the bushing you sent the link to.

So if that is the case ill go with a .451 sizing die if they spring to .452-3 ill be fine as these will be for a ruger nmbk.

Ya thats what i was thinking of doing. First im going to bore it to .445 then polish it to desired size i think. I wish they made a .450 dia die.

Yes it does thank you so my aim is .451-.452 should i go with .429 and open the die up to .450 since there is .002 spring back or just go with a .451 sizing die?

You would have to make somesort of tube to hold the primer in and have the flame follow it and have the fuze in the other end to catch it. Also if u dip the fuse in nitrocellouse/bp mix (take acatone...

Hi i plan on using a 243 fl sizing die for point forming some .451 -.452 jackets bullets that i picked up for cheap. Now when point from these they will end up about .454ish. I planned on using a lee...

Awesome ill look into one they seem fair priced. Im not paying 70plus for a choke that does the same thing as a cheaper one.

Ok awesome and what are your thoughts on the carlsons line of chokes made for the remington guns?

U have a deal my friend i can pay pal you. Pm me with you paypal accnt .

What would shipping be flat rate?

Hi ive been trying different loads in my remington1187 using a full choke(.670)id. My patterns are not as impressive as i like to see. Ive used winchester xr long beard ammo along with remington 4x6...

What are you getting for the 55gr vmax? Im interested.

Yup the alliant powder company got their recipe wrong its where i got my data from...

agreed i know not to stray too far from published data; but i kinda look at shot shell reloading like building a muscle car. got to match the tranni to motor other wise boom busted car "gun in this...

good to know. i did talk to ballistic products and they didnt give me a really good answer nor had much load data. Im going to back the powder off by 10 or so grains and see what i come up with the...