Search:

why not just rig up some kind of spring or elastic bungee to keep the lever tight

you know take a bungee wrap it around the shaft once then attch it to the table and the other end to the lever

i shoot lead in my glock 21 and imi baby eagle .45

i heard its not good to do that in polygonal rifling so i bought replacement barrels for both and have been just fine so far

i figure the...

try just using a spoon make sure when filling you just spill it all over the place it seems to work fine for me i get good fills

seems all my tire guys have agreements with "interstate batteries"

yes airplanes can only lift off within maximum load

http://www.usps.com/shipping/prioritymail.htm


i think the 20 pound limit is for international shipping

the envelope rule makes sense...

my post office told me they could not allow me to ship in the flat rate envelope unless it was sealed "only" with the adhesive strip provided

i had mine taped up

so what i did is just put the...

i use vasaline it comes off the cases as easy as it goes on

i keep a greasy finger to rub on a case then drop them on a white towel

just rub them on a towel when there is a bunch

and its...

yea well either way you're gonna make lots of noise

hmm better not hold the mag on a tec 9 then
http://members.shaw.ca/tmcveigh/Projects/GunRights/images/Intratec_TEC9.jpg

its basically the same as a g17 but has a little nub that comes down from the slide when full is selected and it pushes down the striker release

it is made so that you cannot switch the slide with...

i am down to 134 pounds of my lead muffins i'm staring to get the shakes

http://i43.photobucket.com/albums/e366/bohoki/DCP_7915.jpg

ive done so many with a skillet and a spoon

gee why didnt they jsut have it slide in and have you drop a couple pins through

to remove pull the pins pull it out

ive kind of already been using a system like this i just have my presses...

well i have to agree with the moron cause my lead fouls my bore just like my dinner fouls my plate

i just clean it before i put it back in the cabinet

funny it seems the atf is ok with using a bipod on a pistol
http://www.impactguns.com/store/media/ruger/ruger_4901.jpg

and those can be gripped and used
...

put me down as a cheapskate

although i like the idea of making it myself kind of a spirit of "self reliance"

of course i cant make powder or primers

the lead should melt out the bottom i wasnt aware that spain made any tmj encapsulated ones

teflon is normaly on aluminum i dont melt with aluminum its weakeness point is too close to overheated lead

steel has 1000 more degrees from the hottest i can get with propane or liquid fuels

wha!!! how is this any different than an 80% lower that people finish?

i whack the sprueplate with the thing i use to beat the hinge to get the stuck bullets out

seems to be a solution for everything if you throw money at it

http://www.youtube.com/watch?v=SGYLmHvKVd0

i run my bullets through the sizer unlubed

about every 10th one i rub a bullet on a candle so maybe that is using lube

but i just send through my lee tl design bullets just to true them up i...

i started out with about 5 pounds of wheel weights and though hey i pay $35 for 500 cast bullets from the gunstore

if i can get some gear that would be less than that it would pay for itself...

who only owns one gun?

nobody i know

i use a coleman stove but i use a 6 inch skillet its hard to keep a big container hot

also the pumped white gas ones need to be well pumped and you have to use the knob to extend the tip cleaner...