I have the H & R 1873 Little Big Horn Carbine and recently replaced the crappy rear sight with a Pedersoli Creedmore sight. Inletting was required but a MUCH better setup than the factory sight.
Type: Posts; User: MRGoodwin
Forum: Single Shot Guns
I have the H & R 1873 Little Big Horn Carbine and recently replaced the crappy rear sight with a Pedersoli Creedmore sight. Inletting was required but a MUCH better setup than the factory sight.
Forum: Black Powder Cartridge
I would be more tempted to go with something along these lines
255136
This one was specifically designed for the Trapdoor. It has the necessary lube grooves and should work well in any single...
Forum: Black Powder Cartridge
The NOE mold mentioned in the OP shipped today! I will keep you updated on how it casts and what the performance is like in my carbine
Forum: Black Powder Cartridge
I have only fired 405 gr from my carbine at this point. They seem tolerable...I have only had the rifle for a few months and haven't shot it alot as of yet. I replaced the rear sight with a...
Forum: Black Powder Cartridge
I like the value of the Lee molds but was not overly fond of the hollow base 405. They were a pain in the butt to pan lube (lube getting inside the hollow base) and the noses always looked "rough"...
Forum: Black Powder Cartridge
I was hoping you would chime in Larry Gibson! I value your opinion. Thanks!
Forum: Black Powder Cartridge
I am thinking about getting a new NOE mold for my H&R Trapdoor Carbine. 254865
Any thoughts on this design and bullet weight? I would like to load it over Goex FFg. I had read somewhere that the...
Forum: Black Powder Cartridge
I know this is an old thread but I'm wondering if anybody has any updated reviews of this boolit? I'm thinking about trying this with FFg in my H&R Trapdoor.
Forum: Black Powder Cartridge
I liked the Lee 405 bullet but found the hollow base to be a disadvantage so I filed the HB pin off flat. I now have a 459-425-FB. It shoots well with a veggie & card wad over 65 grains of FFg.
Forum: Cast Boolits
I looked at that boolit and I like it. Unsure of powder at this point but I am a fan of Accurate powders....thinking I will try to work up a load using AA4064.
Forum: Cast Boolits
Thanks for your extensive knowledge Larry Gibson.
Forum: Cast Boolits
I tend to like heavy lead, and in all honesty I guess I'm looking for a hunting round to keep inside 100 yards using the heaviest bullet possible. With a 1 in 10 twist, will the .06 stabilize a...
Forum: Cast Boolits
Dan Cash, I like that boolit. Do you crimp it?
Forum: Cast Boolits
Hello folks! I have been a casting for years but mostly for 45 cal lever guns. I have a beautiful Browning Xbolt medallion in 30.06 that I would like to cast for. I'm sure this has been covered...
Forum: Single Shot Guns
171659
My Swedish roller in 50-70 Govt
Forum: Black Powder Cartridge
What are you using for a blow tube? Just curious if there is a technique that works better than others.
Forum: Black Powder Cartridge
I am going to try a few thin leather wads lubed with pure neatsfoot oil. The neatsfoot oil is used in leatherworking to keep leather supple. I will place a couple newsprint wads over the leather.
Forum: Single Shot Guns
164788
My 1871 Swede roller rechambered to 50-70. I wish I had full wood!
Forum: Single Shot Guns
I have a Swede Rolling Block that was purchased from TradeEx Canada. It was re chambered to 50-70 Govt. I have been doing tons of reading on BPCR and can't wait to head to the range for the first...
Forum: Black Powder Cartridge
Anybody ever try leather wads? Thin veg tanned leather seems like it would do the trick!
Forum: Black Powder Cartridge
Is a boolit .003 overbore too big to start with?
Forum: Black Powder Cartridge
I do a lot of custom leatherwork. Just wondering if anybody may have ever tried using a thin leather wad? Seems like it would be perfect material. Just curious.
Forum: Black Powder Cartridge
I bought it from TradeEx. It was the only one they had in stock with a "very good" bore. The ret of the rifle was beyond rough so I did a bit of restoration. I can't wait to shoot it!
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |