Lee PrecisionInline FabricationWidenersMidSouth Shooters Supply
RotoMetals2Titan ReloadingReloading EverythingLoad Data
Repackbox PBcastco

Search:

Type: Posts; User: buckshotshoey

Page 1 of 24 1 2 3 4
Results 1 to 25 of 583

Search: Search took 0.01 seconds.

  1. Replies
    22
    Views
    2,154

    And of course, they had to walk the old fat guy...

    And of course, they had to walk the old fat guy clear down to #8! Did I mention I am done with the walking thing already.

    315807
  2. Replies
    22
    Views
    2,154

    Resized below 800x600 and it worked. The...

    Resized below 800x600 and it worked.

    The beautiful morning for the walk to the firing points. Absolutely awesome weather..... for now.

    315806
  3. Replies
    22
    Views
    2,154

    Yes there should be. Nothing . I'll have to keep...

    Yes there should be. Nothing . I'll have to keep working on it.
  4. Replies
    22
    Views
    2,154

    I'm having problems loading pictures. After...

    I'm having problems loading pictures. After choosing file, there is no button to press to upload.
  5. Replies
    22
    Views
    2,154

    Arrived at 7:10. Stop to use the greenhouse. Had...

    Arrived at 7:10. Stop to use the greenhouse. Had to make a political donation to the Biden campaign. Ok... I feel 10 pounds lighter now. Start the walk back. I avoid the shuttle. Walking gives a...
  6. Replies
    22
    Views
    2,154

    Off To Camp Perry

    Its 5am. Rubbing sleep out of eyes. Ahhhh.... that first cup of coffee sure tastes good! Entered the Rimfire Sporter Match.
    Going to give The Henry Small Game Rifle a try. It has a Skinner Peep...
  7. Replies
    24
    Views
    2,028

    Forum: Leverguns

    My brother has a Henry 44mag with a 1/20 twist....

    My brother has a Henry 44mag with a 1/20 twist. It shoots standard semi jacket 240's VERY well. I know this is a cast boolit forum, but rifle manufacturers can't design a firearm with reloaders in...
  8. Replies
    36
    Views
    1,624

    Forum: Leverguns

    The COL is misleading. A bullet with a slow taper...

    The COL is misleading. A bullet with a slow taper can be seated much longer then one with a short fast taper. Measure to the ogive... not the bullet tip. Easy to do with ogive gauges. If you measure...
  9. Forum: Leverguns

    Henry is not to blame because your reloads don't...

    Henry is not to blame because your reloads don't fit. Their rifles are made to fit factory, SAMMI spec ammo. Unless you do a chamber cast of both rifles, you can't say the winchester rifle doesn't...
  10. Replies
    76
    Views
    2,374

    Forum: Leverguns

    No one has mentioned, we'll maybe vaguely, simple...

    No one has mentioned, we'll maybe vaguely, simple red dots. Since my eyes are getting bad, I can't use the Marble's Bullseye as effectively as i used to. Especially in dim light. So i mounted a red...
  11. Replies
    76
    Views
    2,374

    Forum: Leverguns

    I have this on my Henry 45-70. WONDERFUL sight.As...

    I have this on my Henry 45-70. WONDERFUL sight.As long as I'm wearing my glasses that is. Farsighted, and hard to see a good front sight picture.
  12. Forum: Leverguns

    Henry 001TLB Small Game Rifle. Mine was dead on...

    Henry 001TLB Small Game Rifle.
    Mine was dead on out of the box. Never adjusted the sights. The
    Skinner peep sight is wonderful. Has Interchangeable apertures that can be purchased from Skinner....
  13. Forum: Leverguns

    I guess it depends on what you're using it for.....

    I guess it depends on what you're using it for.. A 45-70 is not what I would consider a plinking load.

    For the last 2 years I've only shot 5 rounds per year.. Four rounds to make sure it is...
  14. Forum: Leverguns

    45-70 kicks too hard? Why are some of you using...

    45-70 kicks too hard? Why are some of you using 400 grain plus boolits for deer?
    I cast 325 grain and run them in front of 50 grains of Varget.
    The recoil is roughly about the same as a 12 gauge. ...
  15. Replies
    74
    Views
    5,902

    30.06 for me. There are valid reasons for not...

    30.06 for me.

    There are valid reasons for not shooting commercial 30.06 ammo out of a Garand. But if you are not competing in an "as issued" match, why not install an adjustable gas piston? You...
  16. Replies
    17
    Views
    2,419

    Ditto.... it takes very little effort to remove...

    Ditto.... it takes very little effort to remove the crimp, it bevels the primer pocket slightly, and it wont loosen your primer pocket.... like some swages will do.
  17. Replies
    68
    Views
    4,851

    Forum: Cast Boolits

    I have complete lists.... WITH PICTURES! It's so...

    I have complete lists.... WITH PICTURES! It's so easy to do with a cell phone. Its not like you have to go get the film developed! But knock on wood, never had any stolen.
  18. Load up some 147,s and try it. A friends HiPoint...

    Load up some 147,s and try it. A friends HiPoint responded favorably to the heavier bullet. He just used a standard pistol recipe. May not be the same improvement for the Keltec, but it might respond...
  19. Replies
    12
    Views
    2,494

    Also check with the CMP. They have parts up the...

    Also check with the CMP. They have parts up the wazoo. But you may also now have a problem with the gas tube so inspect carefully
  20. It the barrel has been bore lapped, the break in...

    It the barrel has been bore lapped, the break in is basically done for you. You wont find much copper after shooting.

    The reason they want you to use an ammonia based cleaner (like Sweets 7 62)...
  21. I just got home and measured my shellholders....

    I just got home and measured my shellholders. Measuring from the top of shellholder where die contacts, to the floor of shellholder where case head rests.

    My RCBS is .0025 thicker then the Lee...
  22. I got to CMP Special same as you. It is a...

    I got to CMP Special same as you. It is a beautiful piece of machinery! If you use the adjustable gas plug, you will be able to shoot about all factory ammo, with proper adjustment. But you wont be...
  23. I noticed you use the universal decapper. RCBS I...

    I noticed you use the universal decapper. RCBS I assume?
    Then you use a Lee FL sizer. What brands are your shellholders?

    If you used the RCBS shellholder while uncapping, did you replace it with...
  24. Replies
    21
    Views
    2,305

    Dont forget the CMP! Lots of GI bayonets there.

    Dont forget the CMP! Lots of GI bayonets there.
  25. Forum: Leverguns

    Poll: Read my first post.... both are good within their...

    Read my first post.... both are good within their own limits. And its completely fair to quote +P loads. The Rossi will digest them and ask for more.

    As for data, I have this, and can come up...
Results 1 to 25 of 583
Page 1 of 24 1 2 3 4
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check