Search:

Here's my inverted Hornady hopper. Left BE in it for too long...
http://i222.photobucket.com/albums/dd123/steve1981107/Photo068.jpg
You can see how the protected baffle area wasn't affected....

Eddie, as I was doing a search and linked straight to the 32 mag page I never even went to the homepage. I didn't think I needed to jump through hoops to determine whether an item offered for sale...

Thanks for the visual No Z. I've got my WC ordered, now I think I need to keep my eyes open for a 31133 after seeing the bullet and your results. Thanks.

Sadly my recent experience w/ Dillon was not too positive either.
I was shoping around for 32 H&R brass and everyone was out of stock. Dillon appeared to have the item in stock so I placed my...

Anyone use the RCBS wadcutter? I'm thinking of ordering one since I can't find the SWC in stock anywhere and the Lee SWC should be ok for a little while longer. Also, if anyone knows, how does the...

A few of theses suggestions seem very promising. I'm quite interested in some of the older Lyman moulds. I'll keep my eyes open.
Right now I'm on the lookout for the RCBS 32 SWC. Seems...

I guess I should have mentioned that I'd be loading for both S&W L and Mags. Probably mostly S&W L as I have more brass for that.
Those of you who load the 115 gr bullets, do you do so in the S&W...

I recently came across a 9 1/2" Ruger single six in 32 mag. For being such a long barrelled gun, it just feels right in the hand. Funny thing is it sat in my local gun shop for about 4 months or...

I'm in. PM sent.

I'm in!!

I second Cord's comments/suggestions about the driving bands.

Received mine today. Only one problem, I won't be able to use it until I'm done unpacking, building and setting up the new reloading room. Looks good can't wait...
Thanks Mihec

Just a thought but if you cast a HP w/ a polygonal pin you'll have to align/rotate the top punch to the cavity or you will end up reforming the cavity upon sizing. Star sizers excepted.
I'd be...

Thanks to all for the helpful advice. I have a few more questions...
Is the consensus to use Lee sizing dies? Or will the a lyman 4500 work for sizing? Can you use any rifle mold or does it work...

I have been reading a few of these posts on PP boolits but the main question I have is WHY? Is it just to reduce leading or are there also accuracy improvements? Is this mainly for older calibers,...

Sweet! I'm in for 1 too.

I'd be in for this one too.

BTT
Pick this one up PLEASE.

Is this one going forward? Quiet for a while.

Trey, Don't think I want to sell any, sounds too much like work. I might be willing to trade some though. You provide the lead? Check your pm.
Tom, .444 @ meplat. .4555 w/ WW @ front driving...

Found it at the gun show. Knew I had to have it. Good luck.

Riverfun, Thanks, 2400 & unique were my powders of choice. I was thinking of starting around 8 w/ unique so it's nice to see that were in the same ballpark. As for range if I need it for it's...

I just picked up a modern-bond corp mold in .454 wadcutter, 270 grs.

Thought it'd make a dandy bear protection load. Anyone have any loading info?
Hoping for 900+fps in my S&W Mnt. gun. Thanks
...

One more. I'm in.
I never thought i'd see affordable multi-cav hps offered.

I'm in.