Search:

Does anyone know what top punch to use with an a bullet cast in a Ideal 308329 mould? I can't find any info on it. I have found loads for it but no top punch

got ya thanx

Newbie to powder coating here, have been casting for 3-4 years, I tried to powder coat some 45 cal flat nose using the nonstick foil all the boolits came off in one sheet. I have to trim each boolit...

yes it is Ben's Red, Thank God for Cast Boolits for newbies. Been loading forever but casting for just over a year

Well, finally broke and made my first batch of lube. It was the
50% Beeswax
30% Lucas Red & Sticky
10% Johnson Wax
5% Dextron III
5% STP Oil treatment
Next time I'll melt the beeswax first...

I bought a digital thermometer(looks like a small multimeter) that takes K-thermocouples. used an old flexible microphone neck to hold it in the pot, reads fine and gives me accurate temp readings....

I have a design for a .332 bullet to use in the 8x56r Hungarian Mannlicher. Its a spire point bullet with three lube grooves and takes an 8mm gas check. Lee's C329-205-1R mold just doesn't shoot...

Just got done load.45-70 for my 1873 trapdoor
Station 1 -Redding sizing die
Station 2 - Dillon powder measure with 543T powder funnel ( I use it to flare the case mouth)
Station 3 - Redding bullet...