Search:

I'll take

4) Hornady 9mm XTP 90grs (500) count

$128 delivered
Sent from my moto g power using Tapatalk

I'll take the 9mm. I'll pm in morning for paypal information.

I'll take the 452 mp mold. Pm you in the morning for payment info.

Sent from my moto g power using Tapatalk

Interested in mold handles. Sent you a pm.

Sent from my moto g power using Tapatalk

Edited

I'll take number 9 for $85, 5 for $50 and 10 for $40 Pm to follow


Sent from my moto g power using Tapatalk

I do it often, I just use a laser thermometer to make sure I'm not getting over 700 degrees. It's always worked fine for me.

Sent from my moto g power using Tapatalk

I'll take a please


Sent from my moto g power using Tapatalk

I just purchased a MP brass mold and I'm not sure what handles I need. So if anyone has a set to sell me or could point me in a direction to get some that would be just peachy. Thanks.

Sent from...

I just purchased a mp 44 mold and was wondering if I could order penta pins for it? Also it is a gas check mold, I just powder coat and don't worry with gas checks. Do I need to try to open up the...

Just like the subject says, looking for a lee 457 sizing die. Can be in any condition.

Sent from my moto g power using Tapatalk

Edited

I'll take number 2 for $129 shipped. Pm to follow in just a bit

Sent from my moto g power using Tapatalk

Put me on the list for backup buyer for extra turrets please.

Sent from my LM-G710VM using Tapatalk

Pricing?

Sent from my LM-G710VM using Tapatalk

This is what I ended up with. https://uploads.tapatalk-cdn.com/20210105/07ecd4d46cfb12a830fd41a624eddeea.jpghttps://uploads.tapatalk-cdn.com/20210105/a417b5febab8d4dadd4e69c83142a2fd.jpg

Sent from...

I'll take the 6 banger Lee for 35

Sent from my LM-G710VM using Tapatalk

Converted one side of a Lee 457-450 mold yesterday. I am hoping to get some decent expansion at sub velocities out of a 458 socom. I may have to open up the nose a little more to achieve what I am...

In the process of converting a lee two banger to a hollow point mold. It is the lee 457-450-F. What I am wondering is what diameter should my pin be? Could someone with a similar profile mold that is...

Sent you a pm


Sent from my LM-G710VM using Tapatalk

I'll take it.

Sent from my LM-G710VM using Tapatalk

Not sure about a silver eagle but I'd buy them if someone has some 308 brass you could buy.

Sent from my LM-G710VM using Tapatalk

Hell of a good guy right there! If he's a meat eater you could get him a couple big ribeyes!

Sent from my LM-G710VM using Tapatalk

I have a set of dies for 22-250 that I would trade for the creedmoor brass if you are interested. Send me a pm if you are.

Sent from my LM-G710VM using Tapatalk

I'll take it for 25 shipped. Pm to follow

Sent from my LM-G710VM using Tapatalk