Search:

I didn't receive a pm

pm sent

They may not make cars, but the accessories on AERO in the suv model might make you a redneck.

Go to Brownells and get some cerrosafe. If you want the throat it will cast a perfect chamber and throat for you and is reusable.

You might try a local HVAC company they use copper in odd sizes for line sets for heat pumps and refridgeration lines.

Didn't David Kill Goliath with a sling and a stone?

My bible,prayer book,1911,garand. And hope for the rapture before all I could have is the my last two guns.

Just a thought, before you change the chamber try cutting the neck down on the brass and seat the bullet a little deeper. Try a couple and see what it does before cutting a lot of brass, but it...

Look at starreloaders.com. I would think that was a little high. They are becoming very hard to get parts for.

I guess I am getting old, but when I started reloading the info I got was to be careful with any oil near primers, to the extent of not touching the open end of a primer to keep oil on your fingers...

Go buy a drill the same diameter of the hole and put it in. Mine is 15/64, put in the smooth side cut it off a little long and glue a button on it

When I want mine up I use the handle on the lube spring and turn it against the raised handle.

blaser
I feel your pain, but I don't think anyone on this forum will claim it is the most economical way to make projectiles, as it more towards the accuracy and weight control, and ability to make...

The Bahler core swage dies I have do have a hole for bleed off in them

I will also agree I bought some brass and had no problems at all. Good to deal with

Check your pm
Phil

That looks great! The only thing I see can be wrong is that you will get the tool illness and need a lathe at home with a milling machine to help keep the cost down on projectiles, it is a serious...

I have set up a 1050 to size,swage primer pockets, and trim 308 and 223 military brass. Then I clean the brass and send it to the 650. I have a Kiss bullet feeder on the 650, it takes a little time...

At one time I think you were looking for Rediscover Swaging, did you ever find a copy?

Brian
The wall thickness of copper tubing is the main factor, commercial jackets are tapered and thinner than the copper tubing. It would take a lot of pressure to swage up a tubing jacket and a...

If it is one cylinder bored out what about a sleeve for it and save the rest?

I have used Elk Ridge and bought Pacific would do both again with no hesitation.

pm sent for 38 special!!

Thanks for the info, I was told by the fellow I got them from that they quit making bullets at the school in the 70's. I have 5 sets of different calibers and some additional peices. It is fun to...

I have to agree these prices are spot on, but they forgot that cleaned up and working properly they are worth years of quality service and satisfaction!