Search:

Sold pending funds

Looking for a breech block for an original high wall action that is not pitted or worn and all four rails / pads on the sides are clearly defined. My action is pre 1899 but I assume they were all the...

VX Freedom - Still asssmbled and tested in Oregon. Not sure if the glass is from LOW Japan, Taiwan or mainland China but its nice and clear and better than most lightweight hunting scopes we had 25...

SOLD PENDING FUNDS

I've only had this a few months, it's a nice scope but the rear sight on my single shot rifle that this was intended for is pretty far back and doesn't allow me to mount it...

Brand new in the velvet bag with base and screws for Shiloh and C. Sharps modern made 1874 Sharps rifles, never mounted or used. Has both fine windage and elevation adjustments. 200 MOA of elevation...

Sounds like a lot of work. My local furniture store sells nice Amish and Mennonite stuff with traditional door slides that should be waxed, so he sells blocks of parafin in 3/4 and 1" thickness for...

What makes a powder unsafe to download? Detonation from laying too low relative to the primer pocket?

The .270 Winchester seems like its pretty close, slightly shorter shoulder. So would it be foolish to put Hogdons starting loads of 4895 for the .270 into the 7x65R (both with 150gr boolits) and work...

pworley - They are close but I dont see any 4895 loads for the 280 Rem. on Hogdons data center. Maybe 270 Winchester bottom starting loads with similar bullet weights are a good start?

MD -...

So, I've recently come into possession of a post WW2 made 7x65R falling block, and of course I bought a few boxes of factory ammo as deer season starts soon down here. I've also bought a good supply...

Left to right looking down the barrel from the breach or the muzzle side?

I'm specifically looking for this sight, that has the elevation screw down the center of the staff, not behind it like an MVA sight. ...

Whats the traditional direction to REMOVE a winchester dovetailed front blade or buckhorn rear? I believe it is left to right when viewed from the rear of the sights but I'm not sure. I am...

Thanks all!

Id like to mount an MVA sight to an original straight grip rifle. They have the bases but where can I get a longer main tang screw and the front screw for the sightbase (where the filler screw is...

Well compared to what cast, sized, and lubed boolits cost for the 500 Linebaugh its a good start ;)

Found a 40lb bucket of lead wheel weights for $80. We're good. :)

277390

Sheeeeeeeeeeooooot....I still have primers left over from the 1994 panic ;-)

Looking for some low cost plinking / practice options for .50 cal boolit casting in medium - hard alloy (no pure lead).

What are some good sources for low cost ingots or recycled wheel weights?...

Went with Accurate and that 440 grain bullet. Not sure how it will do with the 50-110 Express rifling but its ideal for the Linebaugh with a 4" bbl (5.5" but the muzzle has Bowens counterbored...

Thats .500 not .512

Looking for something in .512-.513 that I can cast for 50-110 WCF and size down for 500 Linebaugh. But nothing available anywhere it seems.

Bump...looking for straight grip rifle unless checkered then pistol grip OK.

Yes I know about the Hogdon loads but I'm out of H110 and want to save my Trailboss for an old British .450 single shot I have. I have this Alliant PP and am wondering if I can use it up on 500...

I have a couple lbs of Alliant Power Pistol powder and a hankering for some 500 Linebaugh. Alliant lists a load for the 480 Ruger with a 275 gr bullet. Would this be a safe starting load for 500...