Search:

I'll take Number 3....45 ACP, LPP, (Qty 1350+) $80/all PM on the way.

I'll take #1, the 1100+ of 9mm brass for $38 PM on the way.

I'll take it, Box 5, 9mm brass
Pm sent

Thanks to all for giving me some ideas. I'll check out the Phantom and Brauer Bros holsters!

I want to take my new .41 Magnum model 57 6" hunting this year. I was thinking of a shoulder holster, but I'm really not sure of what's the best. I've searched the net but didn't have any luck, so...

Bk1saum,
I'll take your holster for $35 shipped. Sending a Pm.

Thanks to all, I've gotten what I needed.

Sounds great, sending a pm

I ended up getting the sizing die and the top punch.

I still could use a holster for a 6" model 57 N frame. I'd be interested in a outside the belt as well as a shoulder holster for hunting.
...

6 inch barrel. Send pictures if you have one. A hip or shoulder holster for hunting would be great.
Thanks.

I looking for a .41 sizing die and a #420 top punch?
I'm also looking for a 41 Rem magnum S&W 57 (R) leather holster.

Thanks

I'll take # 8, 500 pieces of new Starline Brass 45 Colt shipped. PM on the way.

I'll take # 3 and #7...thanks.

281291


I received these as a gift and have never seen this type of bullet before. Can anyone give me some information on this bullet?
I would assume I would have to pan lube these because of...

Thanks Leadhopper!

I have a 375 Winchester and Winchester 38-55 that I'd like to load for.
I heard this Boolit shoots well for both plinking and hunting. I'm also interested
in the sizing die and top punch for this...

I'll take on box, pm on its way.

I'll take #4 the once fired Nickel. Pm follows.

Thanks Geo,

That is very similar to what I had experienced. I bought it new, and the rod was always a little "angled" when installed but I just thought that was the way it was supposed to be. It...

Yes, that's the part. After some searching here, I found that if I bent the rod so that it was closer to a 90 degree angle while hanging, that the stress on the bushing seemed to be much less. I...

Ok, I broke another one of those white $3.00+ flange bushings that will cost me $12.00 after shipping just for one. :x I would like to know if anyone has an alternative to this part. I measured it...

I'll take #5,9,10 if shipping is included. Pm to follow.

I'll Take #1 22.9 # LPP 45 acp brass and #4 the SPP brass approx 345 rounds for the 85.00 for both Pm to follow.

I take #1 Pm to follow

Thanks for the advice and tips! I didn't think all that crud was building up, but it makes sense if you are pushing dust and lube up in a tube for several hundred or not thousands of rounds. I'll...

Yes, I know..."When they get dirty". Is there a range of loaded rounds that I should consider the point when I clean the dies?

I am using a Dillon 550C with Lee 45 acp carbide dies and RCBS...