Search:

I have a closed end copper tube immersed in my lead. It is attached to the side of the pot. My thermal couple slips inside the tube. Works great.

Noe bullet molds has some hollow point molds. I have a 45 mold that will do hp or flat nose. Great mold.

I have a NOE 45 cal mold that will produce both ho and flat nose.

I received my adapter from Lyman. Now to get into storage and get my supplies.

Yes Green Frog, it is addictive. I started with a complete RCBS Rockchucker 35 years ago I purchase from a fellow enlisted man. A couple years ago I started pouring my own 45 hp bullets. I quickly...

My handles are aluminum. Lyman responded that they have 2 of the case adapter. Green Frog is correct on what I need. I will call Lyman tomorrow and May just buy both of them. My nephew my get into...

Sigep that only showed primers. I have the primer die. I just need the case adapter. I called Lyman and the said to call The 310 Shop. I called and left a message. I also emailed yesterday. I guess I...

I am just getting into reloading with the 310. No room to set up my Hornady LNL progressive loader. Thanks for the info about the #2 adapter.

Thanks, I will

I just received my Lyman 310 and 45 colt dies. I did not receive a shell adapter. I have not been able to find one. Does anyone have an extra one they would be willing to part with? I don’t mean...

What if you sized the cast bullet and the pc it? What would the final size be?

If the bullet just falls through the barrel, there is no way it was fired from that weapon. You need to check your other weapons. Does anyone else use your range, with or without your permission?

Put an old saw blade on the hot plate. The NOE mold doesn't make good contact due to the pins and pin holders. Set the spru plate on the saw blade. Turn the burner on high. This works for me.

I use a hot plate to heat my mold. I put a saw blade on the hot plate. My mold is a hp mold so has the pins sticking out the bottom. It won't sit flat on the saw blade. I place it flat on the spur...

I purchashed a used lee 10 lb pot. Cleaned it and lapped the rod and seat. Built a Pid temperature controller. After looking all over and at all the thrift stores, I ordered a hot plate off Amazon....

Yes I mean molds

I ordered a set of 45 hp dies on Christmas Day. I received them today. That is awesome service. It will be very hard to wait until the rest of my equipment gets here.