Search:

Thanks everyone, mods please close.

Weekend bump, I had some leads but lost touch with the sellers.

Thank you.

Rob

Is there a way to subscribe to PM's so that you receive an email when you receive a PM? If so how? I have looked but cant seem to figure it out.

Thanks
Rob

Looking for an old single stage press to set up for dedicated boolit sizing. Doesn't need to be anything fancy. Only real requirement is that it use standard shell holders & standard dies. It can...

PM sent

Still looking, someone's got to have a set laying around.

Thanks
Rob

One last bumb, still looking

Thanks
Rob

Loaded on a 600 jr. 3" Remington "nitro steel" .25" yellow plastic base wad, 32 pellets #4 buck, MG42 wad, 30 gr. blue dot , 4.5cc sperical buffer. Every single shell turns out like these. Same...

I load #4 for fox calling & Lots of 00 & 000 that my native friends use for marine mammal harvest, mainly sea otters.

Rob

MOA, Is stacking buckshot a pain in the butt without being able to remove the hull from the holder on the Ponsness? Seems like it would be.

Rob

PM's responded to,

Still looking

Thanks
Rob

Like the title says, I am looking for a set of 8mm Nambu dies.

Thanks
Rob

Like the title says. I bought 4 flat rate boxes of lead from jetsfan-24 & the communication was excellent, shipping was timely, & the lead is nice,

Thanks again
Rob

The bolt is what holds it straight, via friction between the main shaft & the base. Your press either has a stripped bolt, striped bolt hole, the wrong bolt (if it has a shoulder not allowing it to...

Looks like a good group, just requested membership.

Rob

I am just getting back into casting & looking for a 120 volt furnace, prefer bottom pour. Let me know what ya got.

Thanks
Rob

Go to the hardware store,right next to the graphite you will see "White powdered lubricant".That stuff is motor mica. If the tiny little hardware store here in small town Alaska sells it I would...

What if anything do you use to keep your handloads from tarnishing and, or corroding during long term storage? I was thinking about car wax,just didnt know if it would keep brass from gripping...

To all who have had firearms stolen I advise going to www.stolenweapon.com and doing a search.It helped a friend get a gun back that had been stolen 20 years earlier.

I just bought my first stainless barreled rifle.It was a gunbroker auction on an odd caliber,so I did not inspect in person.The bore is so copper fouled that you can see it with the naked eye.Its not...

your must not be driving a 4x4. I make my living replacing ball joints on fords up here in Alaska.When I lived in Cincinnati everybody had 2 wheel drive fords,and drove nice paved roads.I dont...

I am surprised to hear that breakfree has teflon in it. I was always told to NEVER use teflon containing oil in the bore. As far as "no competitive shooters using ATF" well when I shot high power...

I dont mind weighing every charge,I just dont want to have to trickle every charge. Besides I feel I owe it to Redding to spend some money since the measure I use was bought by dad in the...

Thanks guys for the input. Just found out Redding is now making one that will throw 140 grain. Redding LR 1000,Made in the good old USA