Search:

Good to see your still on here. Thanks for all the help you have givin me.

That's great that people are still looking at this post. By the way the SBH Hunter is still shooting great.
I got a lot of great feedback on this and other post here. Thanks for posting on this...

Thanks for the info....

Hope to get out there as soon as the Striped bass turn on..Gets a little hot in the summer, but so are the girls..:drinks:

Thanks for the help...I just found a Lyman 30 shot M die on e-bay so I grabbed it. Them Redding dies are very nice, but the buck are a little tight at the moment and these rounds are for my AK so I'm...

Hey guys I'm back again for some help with these 7.62x39 brass. I have a Lee sizer that I'm about to through in the trash can. The thing is a pain in the a#$. Need a torch wrench to keep the sizer...

Thanks guys.

Thanks,,,

Hi guys,I'm going to start reloading for my Winchester Ranger 30-30. I have been looking at the lee mold. C309-170-F. Will this work in the gun if I crimp it where the crimp groove is. I don't want...

My bore slugged out to .3135 and at this time I'm using a .313 boolit.

Thank you so much for taking the time to show me this..All of you guys have been very helpful.I'm always learning something about this stuff on here.That's half the fun of this hobby-sport.
...

Ok..Thanks for all the help here you guys..I now have many thing to look at..I have tried to look up load data for this boolit and there just is none out there. Like I said above,I started out using...

Now that I noticed that there on one side of the brass I think you my be right. This is where I got my data for that load. He is using a 180 grain boolit so I thought I'd be safe with that load....

The primers look fine. I did notice that the dimples are on only one side of the brass. The dirt on the brass is from the tumbler.56984

I didn't notice and there in the tumbler already. Just bought a pound of this powder yesterday.I read on here a few guys using it. It seems that the one @ 22g where the worst..??

Hey guys.I could use a little help again. I have been loading the 7.62x39 for my AK and today when I came home from trying out some new loads I see the brass on the ones I used the 4895 (IMR) had...

Thanks Ed...:drinks:

Thanks...:bigsmyl2:

Thanks for all the help guys. Didn't want to wait for a expander so I made one.Works great.



55832

Thanks.

Thanks. That's what I was thinking. I want some tension but not so much as to reform the boolits. I was told to go shot some rounds off and see what the size of the ID in the neck was, so that is...

Thanks you guys. So what size M die do I want ? The .30 cal? Sorry guys but this part is new to me. Going .313 with the boolit how tight should the neck tension be..311,.312..???? lol..

Thanks.I was hoping now that I have this set, there was something I could do..

Hi guys. I just got my Lee 7.62x39 Russian in the mail today.It came with two decapper rods. One is close to .308 and the other .311. Now what do I do if my boolit don't fit because the neck is to...

Your the man..Thanks