Search:

Yep, good - until you realize the groove diameter is 0.002" greater!

Been harvesting firewood for heating since 1976 and done it all sorts of ways. Have a real heavy duty shop made hydraulic splitter but now only use it for the bigger and/or gnarly stuff. Discovered...

If you asked this question verbatim: "Am I able to legally take a revolver to California while I go on a pack trip?", not only would you not likely receive a response but in the off chance you did it...

I'll take the JP Lower Parts Kit. PM sent

PM sent on Talley mounts

I believe we castboolits types think there is more demand than in reality there is at times. I actually fell into that trap when complaining they had 475L in stock and no 480R despite it being the...

I agree with Don, good post.

It might help for some perspective that they will be looking for an order closer to 1 million than any figure mentioned so far in this thread. Yes, we're talking a...

Larger case head = more pressure on the breech. You can fire 223 Rem 55Kpsi all day long but one shot with a 475 Linebaugh (50Kpsi) and your Contender is toast. Given the same case head and pressure,...

Yes, and then how would the Blackhawk chamber compare to the Contender chamber made from yet another reamer?

The farther one goes down this rabbit hole crafting handloaded ammo with cast boolits,...

Looked at the butt-ugly Hogue grip on a SS SBH in a local shop 20 years ago. Picked it up and the grip was wonderful! Still don't have one. :confused:

"Electronic trigger" - Point firearm downrange, manually pull trigger and AI decides when to fire based upon sight picture.

SPF to Bloodhound689 IN TWO MINUTES!!!

Thank you!

This mold has never been used and is in perfect condition. Mold cost today is $109.76 shipped to US and out of stock at MP Molds.

$90 shipped in US PayPal F&F, USPS M.O

323492
323490
323491

Is this discussed somewhere on the forum? I searched but could not find it.

It's a gunsmithing operation.

A buddy bought a small Chinese lathe for $500 or so. Immediately began to lay out money for tooling. A few months later I purchased a 13X72 South Bend for $750. It came with an almost new Bison 3-jaw...

Donated food is wasted because all on the dole are eating BigMacs.

I'm not one who can contribute as having never owned one but am watching this thread. It is not uncommon for a cartridge to be given a status of performing out of proportion and the 41 seems to be...

SPF to bbassi

Bump

Video posted on Youtube in the last hour: Thank You for 1 Million Subscribers

Since the original post that’s 180K subscribers in two days!

Seen him before but never subscribed - taken care of today!

Lot of 150 pieces of once fired 35 Remington brass

Breakdown:
136 Winchester headstamp
10 Remington headstamp
4 Federal headstamp

$125 shipped

Heated with wood as a supplement from '76. In 2003 went wood-only. After about 12 years of that decided to buy an inexpensive pellet stove with gov't tax credits and self-installed for not much more...