Search:

EFR Leupold. Got a couple of the 6.5x20x40's mounted.

Sometimes the alloy and/or mold block temps are too high.

A friend that prototypes and manufactures power supplies for electrical equipment says about all his customers specify lead free solder. He knows from experience that lead makes the solder joint more...

What about the lead from the priming compound? You didn't mention it.

I'm sure they were a 4 pack for a buck. Fortunately I wasn't the end payer for the $5 each bulbs. I ended up buying a milkhouse heater for the pump house with the filter, pH and pump control/well...

I repaired my first dual fuel slide in range today. Complaint was that the oven wasn't cooking the food completely. A Kitchenaid model KSDG950ESS1.It's in the island so it's downdraft exhaust. Not...

I use incandescent bulbs in a few pump houses to keep them from freezing in the winter. This past winter they were near impossible to find. 4 100 watt bulbs cost $20 at the appliance parts store....

Why should I ignore what somebody has to say? I realized that when I came back stateside in 1974.

What's an ignore list?

I had a little trouble with sizing after PC. I used a lanolin/isopropyl mix to lube before sizing. Increased my bake time to 30 minutes @ 400degF and the lube ain't necessary. I coat as soon as...

I've loaded a bunch of different rounds. Maybe swapped the shell holder plates 5-6 times and used the LS jaws twice in 20+ years.

Just wondered if you had been at the groundhog shoot Saturday morning and I might have passed you.

Hey Beemer. Was you at Hickory yesterday?

I ain't had no extra room in a wad or hull with naked buckshot. Adding more diameter means less buck and which means less payload. Can't say that I'll be PCing anything for the shotguns in the...

I thought I saw it was reintroduced.

N3SL = N318 . If you can't find N318 load data just back off N320 and start from there. Or call Vihtavuori for help. I shoot N310. It's max load is below start load for N320.

Those numbers look a lot like COWW's mixed with equal parts pure lead also called 50/50 around here. Some folks crank the heat to get good fillout with that alloy but with the higher temp have more...

They look terrible after they've been sent downrange.....quickly.

Maybe the fella really can't hit the 200 yard berm with a 9mm. No telling where his shots are going. You and the clubs liability sets on this no shooting rascal's shoulders. That's why I got out of...

When I block a set of holes on a star sizing die, I dig through some lead bird shot and find some of the smallest pieces. I use a brass hammer to get one in position so a little is hanging clear of...

They'll go both ways. I do nose first too. I had a die act up without the gas check. Some polishing compound took care of it. I like country gent's idea of deburring.

Mine look just like these except a little longer and a little skinnier. 4 fit in my Oster countertop convection oven with a little room to spare. Each will hold about 3.75 lbs of bullets and I can...

Is some of the gas check getting hung on the lube holes in the sizing die? Maybe base first instead of nose first?

That's good. Some folks that do a search don't.

I saved a bunch of handles and feet. Melted them together and sent a sample to BNE to be tested. The result really surprised be. There was next to...

That's a really good start. Watch the stuff with handles and feet. They can surprise you. I do them when I got a good amount of melted pewter in the pot. I'll put them in and keep an eagle eye on it...