Search:

If anyone wants this bad boy, contact me via pm.....like 35 shipped will work.

Doug

It was more like .464"

Hmmmm, that sure looks close.

I assume this is a custom made mould, it is an Ideal block, but it sure looks like an experiment. I was thinking a lightweight plinking boolit for .45-70's but it has provision for gas...

....Yes, I would go with the Blackhawk.

I have the first two. I would say the Blackhawk wins for versatility, as you have such a variety of loads to shoot. Think about it, how many different 45 acp loads alone, plus the 45 Colts....which...

This sure seems like the perfect mould if you own a 1911 and could only own 1 mould. Of course we all know you just can't own one mould....I'm just saying.

190209190210

Has anyone loaded this combo? When I use the existing crimp groove, the loads seem to long to seat in the cylinder. Is the solution just to seat back further, or buy another pistol in .454? Any...

I also posted in the "wanted" section of the buy/sell section. I have a buddy that owns a great old family gun, a like new Model 14 in the 25 Rem caliber. I would like to be able to get reloading...

I may have over paid a bit for these two, but some fine examples of beautiful old Ideal artwork. Both square groove, the Keith is pretty early both pre-vent and standard set screw for sprue plate...

Another wunnerful Lyman service story that is unfolding....

I had a 68569 that I picked up without a plug. Well, normally I have a great machinist from this site make all my replacement pins and...

188911

"395", not 495 though.....

Is this version common? I have a 2 cavity, and don't remember ever seeing one. Lots of the hollow base SC variety.

Doug

I'd love to see the Slippery run again, through NOE!

I'd like a nice copy of the original '344 if it does happen.

Doug

Brownells had a good deal on one, under $100 with shipping. Just bought one two weeks ago, but will be a while to put together an upper.

+1

Doug

I might be in as well.

Doug

148491

Thank You Frank....I just got a SC Ideal, and posted a interest thread as well. Real cool bullet.

I came across a nose pour 30 caliber NEI, just wondering if it is original or someones after the fact work. It has a pivot at the bottom with a disk, and opens and closes a lot like the hollow base...

Justin, we must have the same guns.

d

This does look cool.

Just picked up a nice old Ideal 323378....looks veeerrry long. Any interest in a re-make? I will post photos.


Doug