Search:

Can anyone identify what this magazine might fit? Holds four rounds of 30-06 and the only marking is an "E" on one side.

Thanks

316273
316274
316275

Had the same problem with mine when I first got it, replaced the main spring with no results. Ended up putting a spacer under spring worked like a champ.

For many of the older couples, parting has had a corrosive effect on others who tried to contain and guide them.
And many have also been quite mercurial.

Have been a member of that establishment I can say that all rifles are M14s no M1A1. There are no firing pins in the rifles when at VMI and for the last Inaugural parade the bolts were removed.

Thanks fellas

I dont believe that mine has been fired very much. The only problems it has are some minor pressure marks on the toe of the stock.

LimpingJ, it can still be yours.....

Thanks, you wouldn't happen to know what the difference is between the sharps christmas tree and the moose sharps ringtail?

I picked up an early shiloh sharps 1863 sporting rifle in 54 cal this past weekend. Need some suggestions for a good mold to use with it.

Thanks

I have a shiloh sharps that I am looking to sell and I needed some help getting a ball park figure for it. I haven't found any that have sold recently and was hoping that someone here could help. ...

Thanks fellas

No markings anywhere on the cylinder. Length is 2.20 diameter is 1.60 bolt notch 0.14 inches. So I guess that its not a uberti based on the length nor a cva based on how the...

I picked up a 1858 44 cal cylinder in trade that I dont have any need of I was planning on selling it but I dont know who made it. It works in a pietta 1858 that I own but the bolt notches are not...

Thank you gentleman for your help. The photo by montana charlie is greatly appreciated.

I recently purchased a c sharps 1875 rifle 45 70 with their midrange sight. I am unfamiliar with using this type of sight and was wondering if someone could help me understand how to read the...

Sorry about that, first time filming.

Case Ejection


https://www.youtube.com/watch?v=5FsF-vpOd9c

Bullet Feeder


https://www.youtube.com/watch?v=k7FiQ0L8cfM

Priming Video 2


https://www.youtube.com/watch?v=59qar_Gqx14

Priming


https://www.youtube.com/watch?v=Ov8t6aVmHN0

As some might remember I did a post some time back on how to use “The Tool” a reloading press by RDP. While many felt that the write up was very informative flyingmonkey35 requested a video of it in...

Same, I tried for one of the shilohs as well

Amazing

Three44s

I got in touch with Rickets shortly after I bought this. He told me that he had sold all the parts he had to someone who has fallen off the face of the earth and, the prints were sold...

Thanks guys, this is quite intimidating and I am sure it will still be working long after I'm gone. Stonecrusher thank you for scanning that article and, yes I did see references of this press being...

132210


Photo 10


This is the most complex part of the whole machine as it controls both the primer seating and rotation of the shell plate. The octagonal column in the foreground is...

Background
In July of 2014 I went to a gun/reloading auction in Harrisonburg VA. Looking over the stuff that was being sold it appeared to have come out of somewhere that might have done commercial...

Thank guys, i'll the mold a try and see how it works. For sizing dies in that range of 0.349" to 0.352" the only place that I have found that carries them is buffalo arms custom dies for the rcbs...