OK guys,
I loaded the lead pot and doing as Mike W1 suggested (set in Pid mode) watched temp. until it was 30 degrees below set temp. and reset to self tuning mode. By the time I got it reset the...
Type: Posts; User: Old Ugly
Forum: Casting Equipment
OK guys,
I loaded the lead pot and doing as Mike W1 suggested (set in Pid mode) watched temp. until it was 30 degrees below set temp. and reset to self tuning mode. By the time I got it reset the...
Forum: Casting Equipment
Mal Paso,
I believe the Pid is on. Here are my settings in the Pid mode. Control period-1, Proportional band-1, Integral time -540, Derivative time- 200. These are the settings suggested by brewer...
Forum: Casting Equipment
Thank you all for your input. At the very least it lessens my fear of going into the settings and experimenting with them a bit. I have the flow chart that came with the controller and a list of...
Forum: Casting Equipment
Hope everyone had a Merry Christmas, Happy New Year and stayed away from the BUG.
So I pieced together a PID controller but am not happy with it. When the pot temp. reaches set temp. the
out light...
Tripplebeards,
I will try to check out your suggestions.
A couple of things I should point out, Walmart here doesn't sell anything gun related. I'm not sure if this is across Canada or just our...
Hi again,
Many thanks to all for their input.
I read the survey in the thread "Rifle scopes, the good, bad and ugly'. I then went to amazon and e-bay to check out the makes and models. while doing...
Thank you all for the replies.
I assume with high mounting rings the safety on an 03 would work. I only load one round at a time but having a usable safety would be a good thing.
I originally...
Hi all,
First of all good luck to every one during these tough times.
When I was at the range the other day one of the members had a Tasco 6 x 24 x 50 scope he wants to sell for $100.00 Can. He...
Forum: Cast Boolits
So I went out and tried to do a ladder test but things didn't go well. The weather wasn't very good, cold and over cast, below freezing and my eyes wouldn't stay focused on the targets. After a...
Forum: Cast Boolits
Bigslug, thank you for your input.
I think you are probably right about the grove diameter being larger than .312 considering the difficulty measuring a slug from a 5 grove barrel.
Since my last...
Forum: Cast Boolits
Conditor22,
Thank you for the welcomeing, your response and the link.
When closing the bolt with a fired case with a bullet in it the crimp grove is right where it should be. The OAL is about...
Forum: Cast Boolits
Hi all,
I've been lurking here for a couple of years and finally registered today. I need some advise.
I am playing around shooting PCCL boolits out of a P-14. The barrel slugs out at about .306...
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |