Search:

I am building a 357/38 rimless, anybody got information on this cartridge.

I essence its a 223 case cut down to 357 length; re sized...

Any information would be helpful.

Regards

I am building a 375/38 rimless, anybody got information on this cartridge.

I essence its a 223 case cut down to 357 length; re sized...

Any information would be helpful.

Regards

I take your point thank you for your reply...

This has made me think i should sell my star sizer...

Guys im looking for a little advise here.

I have a full set of BT Snipers 223 bullet swagging dies include, mold and ejector which I am not using. I would like to rebuild my reloading bench and...

Many years ago (on internet), I had the larger machine with four molds, the element went on that, being in the UK i had real issues sourcing an element. In the end i had one made up that i retro...

I've just commissioned a copper bullet design. So I can judge whether its worth getting them made to sell on or just for me to hunt with.

Once i get a price i will let you know.

Could i order 2 Cavity Brass solid, machines mold, 155bb. DPM308 dot @gmail dot com

Thank you very much guys, very informative.

Guys ive got the opertunity to buy a bare Armalight AR10 lower, its used and that amounts its been been used is unknow.

My question is will the modern day parts fit?

Regards

David

Thank you Guys. Some great suggestions and advice.

Can anybody recormend a 223 mold. I'm looking to use as a pactice round, 100 metes and less. For use in a AR15 straight pull.

Thank you i didn't think of that... I will let you know.

I have made some 62 grain RF bullets and loaded them with 24.3 grains of N135 and traveling aroung 2,850 ftps. I use the Serria reloading manual as a refferance which has neaver let me down.

I...

Thanks Trevor

What temp and for how long?

Trevor are you pre-heating your bullets to ensure they are dried fully?

Bevel please

Ah, that's clearer thank you. I was using a plain non coated bullet. I will get a infrared thermometer as advised.

Once again thank you for your help and support guys.

Mozz

My mistake i've coated with a 10gms to 100mils mix, as I have only been coating 2kg of bullets at a time.

So just to be clear I am sure that the coated cast bullets are reaching temperature, the oven is controlled by a PID and the thermal couple has a bullet screwed on the end of it. Once the oven has...

Can I have the 155 SOLID in bevel base, in a machine mold - ive spoken to the guy.

dpm308 at gmail dot com

Thanks for your reply. Its powder Hi-Tek, it must not have dried properly, because its defiantly getting more than 2 minutes at 180C. I coated some more this time with Red Copper which did pass both...

Any advise would be helpful.
Mozz

OK what am I doing wrong,

2kg of bullets, 10grams (CAR) mixed with 100 mils of Acetone.

Baked at 200 for 13 minutes. Oven has a PID and Fan and both seem to work well. Covering looks good.
...