Hello, I am looking for load data for wc 820 lot 47320 to use in 357 mag, 44 mag, and 45 colt. Any info will be appreciated. Thank You
Type: Posts; User: 12slugger
Hello, I am looking for load data for wc 820 lot 47320 to use in 357 mag, 44 mag, and 45 colt. Any info will be appreciated. Thank You
Thanks for reply, I just picked up the rifle today and haven't slugged or measured the twist yet. I have the lyman in a round nose version and will try it. Not sure of the proper way to lube it...
Just picked up a Savage 99 in 308, looking for tried and true cast bullet loads for hunting with this rifle. It is a rotary magazine. Any help will be greatly appreciated. I don't know if I can use...
thanks again, we are waiting for the dies, and should be started loading any day now
Hi could anyone tell me what the mold was designed or used for thanks Steve, pioneer mold #45912665
Thanks Fellas, I hope someone replies with actual experience in loading the win 300 short mag, I am not much of an experimenter, that nightime hog hunting sounds like fun though, wish we had some...
Hello, I am looking for some info on loading 300 win short mag with cast bullets, mostly for target shooting, any info will be appreciated, Thanks Steve
Forum: Factory & Surplus Powder
Thanks alot fellas, I will do a little research along these lines, and really appreciate the advice
Forum: Factory & Surplus Powder
looking for info on using this powder for plinking with a 458 win mag mauser action heavy barrel target rifle any experience or suggestions appreciated, ( I have 30 pounds) and I dont want to sell...
Forum: Cast Boolits
Thanks, I am going to try again tommorrow
Forum: Cast Boolits
I packed the pieces into the pot and then fired up the 3 burners, as it melted i kept adding the foil to the pot when it all melted i threw in a chunk of beeswax about the size of a heaping...
Forum: Cast Boolits
looked at the cooled down batch this morning, there is about 30 lbs lead that cooled in the pot and there is 3/4 to 1 inch deep yellow dust on top of it. any ideas, and i know the temp was over 1000...
Forum: Cast Boolits
Thanks for replying, the lead looked like hot ashes all the way through, or it looked like the dirt you skim off the top except the dirt was 6 inches thick and my dipper kept comming out with yellow...
Forum: Cast Boolits
just started using a johnson furnace today and i think i might have ruined a batch of dental lead, I melted the lead and tried to flux and it was like stiring very hot dirt, may have been over 1000...
Forum: Casting Equipment
Hi looking for a custom 7mm sizeing die to fit lyman 450 please pm me thanks,
Forum: Cast Boolits
Does anyone make coppies of the old Ideal adjustable base 30 and 38/55 adjustable base molds with all the grease grooves? thanks,
Forum: Group Buy Results
Please put me down for a two cavity, thanks Steve
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |