Search:

I have worked with Tom quite a few times such as:

For 9mm
35-146A

For 38/357
36-165M
36-165MG
36-165N
36-165NG

For loads as described by the original poster, I use HS-6 with great results. It meters great, has a reasonable pressure curve, works great with jacketed and cast, and has produced fine accuracy for...

I actually had 5.5 Redhawk many years ago and it was stolen. It was VERY heavy. Too heavy for carry to me.

Mark in GA

Hey guys. I've been looking around at used 629's recently and thinking about picking one up. I don't usually care for the overly heavy full underlug style barrels, so I am looking at the 4" and...

I have a few Lyman 4 cavity moulds (358665, 429667, 452630) that have varying degrees of bevel to their bases. The RNFP designs have less than the H&G clone 452630, but honestly I would prefer that...

In regards to it hanging on the meplat, coule it be that you are seeing a cartridge OAL problem? How long was the 429667 when loaded in 44 Mag brass? Was it 1.600"? Or longer?

I have seen some...

I actually have ordered a 4-cavity version. I realize this design is not going to cut nice clean WC type holes in paper. I am most concerned about feeding and accuracy. I am trying to find a...

I have been thinking about getting a 4-cavity of this design to use as plinker in 44 Spec/44 Mag sixguns and a Marlin 1894SS. I was curious if anyone had any reports on it they could share.
...