Search:

That sounds great, I'm glad you found an answer to your problem.

I also own a Smith & Wesson 625-8 Performance Center 45acp revolver.

After reading this thread I slugged the bore and it measured .4535 using a micrometer. The cylinder throats measured .453...

You will enjoy shooting the S&W Model 16's Here are a few that I shoot regularly.275544

As for cast bullet diameter is concerned, I measured some cylinder throats with plug gauges and found : 6...

I very seldom purchase a new manufacture handgun but I could not let this one pass.
Freedom Arms Model 97 in 327 Federal mag. with a 7.5" barrel and micarta grips, it also has a factory action job....

I had a very large quantity of Lapua swaged lead bullets that had the defective lube or lead dust on them. They would lead the barrel of my Walther GSP terribly in less than 50 rounds. I did the...

253768Here is my Mdl No.3 Schofield 7" 38Spl. from Cimarron Firearms Co. It has about 1000 rounds of my target 148 grain HBWC through it without any problems. I use the light loads only because I...

253444 Here is a picture of American Holly on a clone Schofield.253445 Also on a Ruger.

Almost forgot a Dan Wesson 732 VH6.235179
I should add my Walther GSP in 32 S&W Long. It likes a larger dia. swaged bullet to about .3145235184

Some Smith & Wesson 16-4's.235178
Also my Smith & Wesson, Hand Ejector, 3rd Model, 32 S&W Long.235185

Some Single Sixes in 32 H&R. I had to modify the front sights to get the P.O.I. adjusted to my light loads. They both shoot a ragged hole @ 25 yards.235175235176

I always enjoy my time with this 1941 Colt Officers Model, 6" Heavy Barrel. The load that I use is Starline 32 S&W Long brass, Missouri 98 grain .313 DEWC with Hi-Tek coating, HP-38 @ 2.0 grains, and...