Search:

I have 3, with 3 different jaws, and I have had them for 30 some years, great press.

I just picked up a Marlin Model 27-S in 25-20 and the hunt begins. Someone local had 9 32-20, I pulled the bullets, lubed and partially sized the, remove, lube, partially size, etc, and the first one...

May I ask who did the conversion on your revolver?

In like 11 grains of Trail Boss and a 405 cast plain base bullet.

It is the time to look at new sites that we find very thoroughly. I found a sight that had magazines that I needed and when I put in my order with a credit card, I received an email stating that we...

I use BE 86 in my pistols and blow back AR and AA 7 in my direct impingement AR.

I use the Lyman for wet tumbling, a Cabela's for sorting different size brass and the Dillon for the dry media.

45 Auto Rim, turn rim to .504 diameter, thin rim to .036, trim to length. I would have to look through my reloading notes but I used the lead RP 45 Colt bullet, it is concave on the bottom and about...

220 Swift is the easiest but with the low price of proper headstamped brass why bother.

When I was shooting 8mm Nambu I would use 357 Sig cases. I would first run then up into a 30-30 sizing die far enough to size the rim and head to the proper diameter and then knock them out with a...

I have been looking for some for 6.5 CM.

I use it in 6.8 SPC.

I have some Alcan that I am still using without issues.

I will be there next week. Thank you.

I didn't know one could have too many.

Such a waste.

Great find.

I used 357 Sig brass, run the case up into a 30-30 sizing die until the rim/head is the correct diameter. I used a steel rod to knock it out. I fabricated a rod to push the case up into the 30-30...

Try 243 brass.

My favorite load in my 1895 CB is 11 grains of Rail Boss behind a plain base 405 lead bullet. The 200 yard gong doesn't have a chance, of course is a slight wait between the bullet leaving the barrel...

I have always been partial to the SMLE or 1903a3.

That is a great looking rifle. The ones that I have had in the past were very accurate. Makes me want to get another one.

I use CCI, WW and Federal and I haven't had any problems.

Second on the B&M powder measure.

Fun to shoot and a nice looking gun.