I use Cura exclusively. I was able to get a complete print by setting the layer height to .1 and the fill to 95%. When the print finished I could see through the section of the body where the recess...
Type: Posts; User: kmitchl
Forum: 3D PRINTED RELATED ITEMS
I use Cura exclusively. I was able to get a complete print by setting the layer height to .1 and the fill to 95%. When the print finished I could see through the section of the body where the recess...
Forum: 3D PRINTED RELATED ITEMS
Any tricks to printing the 45 cal bullet feeder die? I have tried twice. Both times the wall thickness at the recess that lets the balls retract to allow bullets to pass is so thin it fails in the...
Forum: 3D PRINTED RELATED ITEMS
In reading this thread it appears that a number of people have made significant contributions to the open source bullet feeder. I printed most of the parts I needed for a 9mm setup back when...
Forum: 3D PRINTED RELATED ITEMS
Does the collator plate ride on the bottom of the bullet feeder case or is there a spacer on the motor drive shaft that spaces it above the case? In looking at the MBF motor there does not appear to...
Forum: Gunsmithing Tips & Tricks
For me personally I don't NEED a DRO, however, as others have said they are very nice to have to do accurate work quickly. The Grizzly DRO's are over priced IMO. Look at the DRO's on Ebay. I've owned...
Forum: 3D PRINTED RELATED ITEMS
Well sad to report the printer collator plate driver failed right below where the wing connects to the shaft. The shaft is hollow at this point. A small tweak to the CAD model would fix this.
Forum: 3D PRINTED RELATED ITEMS
Well I printed the drive device for the 370 motor. It seems to fit well and has a shoulder to raise the collator plate off the bottom of the bowl. Not knowing the torque available from the motor or...
Forum: 3D PRINTED RELATED ITEMS
I have the same question. In looking at a number of YouTube videos it appears that the drive for the collator plate is just a cross pin through the shaft. So the collator plate slides on the bottom...
Forum: 3D PRINTED RELATED ITEMS
I guess I'm late to the party but I just started building the bullet feeder. I just completed printing the 9mm collator plate. Took over 18 hours. I used .16 height, and 80% fill. What settings is...
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |