Search:

Here is a 400/gr and 500/gr 50/cal jacketed bullets, several types, made using a 45/ACP case for a jacket.
Made using a hydraulic press and Corbin H-Dies.

325394 325395

Yes, I know Dave sold the business last year. The new owners are listed on the new website.
Be prepared for the new price increases.
Dave kept them down for the last ten years.

Yes, probably if you ever purchased something in the past you received the email.
The only issue with the new website is that all the previous die combinations and pricing have been removed.
For...

Here are some 0.458 300/gr, 350/gr and 400/gr copper jacketed bullets recently swaged.
These have a 0.250" meplat basically used in a 45-70 lever action rifle.

These all cost less than $0.10...

Photos of the finished bullets is all that I will post or have the time for right now. The process is pretty much the same as making any caliber jacketed bullet.
I use a hydraulic press which...

For those interested, I believe these are some the original pictures posted making 357 or 357/sig swaged bullets.
These were made using 9/mm drawn cases for jackets.
The full length of the case is...

To the top

To the top

To the top

Sasquatch-1, I looked into your suggestion of using 10/mm cases for jackets. I didn't realize they are about 0.140" longer than a 40/S&W case.
I would definitely use them for the heavier bullets. ...

Looking for 250-1000 10/mm once fired brass cases no Nickle or possibly new depending on price.
Contact me with a reasonable total price shipped to 44023.
Thank You

I haven't considered using 10mm cases only because I use the 40/S&W cases for 44/cal, 45/ACP and now 45-70. I may have some from range pickups and would make some samples if I ever have the time. I...

As promised about fourteen months ago to post the finished bullet results, I finally received my Corbin H-Style 0.458 caliber die set. I'll be using them in my Uberti 45-70 but believe they are the...

I started swaging my own bullets because it was a very interesting and involved hobby. Plus, you don't have to rely on anyone else to get them. Cost is always a factor and to do it right the first...

Here is what is possible to make 9/mm or 357 swaged bullets. I had posted making these awhile back. Like everyone has said be prepared to what it will cost to get to that point. I first look at...

I had to post this again to show what a swaged 500-S&W bullet would cost if you had the setup.
These were made using annealed 45/ACP full length cases.
These probably cost me about $0.05/each. ...

Dave sent me a one-page response about a month ago about the status of the company and how it is running after I wanted an update on a current order. If he's lucky there are maybe two highly skilled...

I agree for the most part Dillon does have a good warranty. I also had an alignment issue, and it wasn't that easy to find out you needed an alignment tool. For the cost of the XL650's, I have two...

I was hesitant for years to get an ultrasonic unit. First to get one large enough to do a large gun like a 500 -S&W with a ten-inch barrel. The second concern was the cost of the solution and based...

Just some information, Corbin uses three equally spaced bleed holes on the 1.5" core dies.

10sandsxs, I don't know if you have ever read any of my posts under swaging bullets. Right now I don't think I have any of the 45/acp bullets I swage using 40-S&W cases for jackets posted. Mine are...

Please close, thank you

Please close, thank you

Please close, thank you

Last offer to sell before asking to close