Search:

Using the following for my Trapdoor

60 gr Triple Seven FFG by volume not weight
515 450 gr FN HB NOE Mould
SPG lube Hand Pressed into groves
.030 Fibre Wad
2.230 OAL
Slight Crimp to remove...

Here is the load I'm using with IMR 4227. I started with 37 GR which measured 1540 FPS which is darn close to what Quickload defines. Will work yo to 40 to 41 GR once I can get back to the range.
...

Haven't tried any other but happy with this mould. http://noebulletmolds.com/NV/product_info.php?cPath=43&products_id=638. It's the only thing I have run thru my Beowulf.

Fellow casters, I have been requesting of Sheridan to produce a 30-06 Gauge for my cast loading. I use their gauges for .223, 300 BLK and 50 Beowulf and have found them to be indispensable for cast...

Curious about your load data, can you share?

Thanks for the info, will see how the 300's run for me. Been loading up x39's using Hornady jacketed in a SIG 556R but they are too expensive too shoot, hoping the casts run as well.

What's the OAL for the 300 load?

Also, what's the load for the 7.62?

Would be interested in seeing you load specs for the 300 in that 155 bullet. Would you mind sharing?

Yup, that the 247 alright. Using it for subsonic out of a 300 Blackout. Casts really well and shoots even better!

Watch the lock dial on the craftsman PC gun. Look at it wrong and it breaks off. I broke mine simply wiping down the gun and it popped right off. Although the extra stuff is needed such as a...

Reporting back. So far after 8 hearings to 400 +/- the silicone grommets haven't shown any signs of melting or hardening.

No electrostatic using the HF gun

Just shoot it, since it doesn't ride the barrel it's all good.

Not sure of the temp difference but these didn't melt or deform at 400 degrees in my cheap-o oven. Will see how long they last.

The Granger part number is the same number which Minor sells them. Of course the price is better! Grrr

Here are the specs for the ones I got...

ID 3/16
GW 1/16
GD 5/16
OD 7/16
THK 3/16

Got these from the distributed Minor Rubber

So, got frustrated with the powder coating process because I couldn't keep non-gas checked bullets standing in the drilled tray. After trying various size holes with no luck keeping them standing...