Search:

BT do you have any load data for it?

I have some Dixie Slugs (see attached) that I have been looking for some recipes.
They are all .730 in diameters
Any help would be greatly appreciated.

I had Scott Parker redo a Lyman M5 a while back and it is very sensitive and accurate it is my check on the other scales.

I'm in.
joharm at aol dot com , HP 432 GC 2 cavity brass all pins

I have a 1966 AB serial number New Haven.
Blue is 97-98% no marks on the bolt or loading cover/door.
Wood is 93-94 % Not the best-looking wood to start.
The only nonoriginal item is a limb saver...

The ones that I have from the sixties are all steel. I have never seen Aluminum ones. Neat

When I got my Marlin 44 it did not shoot well. I disassembled it and found the mag tube was putting pressure on the barrel band because the tube was touching an area on the receiver. I ground the...

I like the RCBS bench primer tool, that uses the regular primer tubes. I t has a great feel and strength.

Hi
Three RCBS uniflow
one pact scale and dispenser
RCBS 10-10
Ohaus 10-10-
Parker Lyman M5
jennings gem scale a
small pocket scale

I'm in.

joharm at AOL dot com, 2 Cavity-.680 Diameter-All Pins, 32934

When will the full bore list get started?

Hi,
Just got mine in the mail
paid 7-17
shipped 7-19
in NYC 8-5
in limbo, till 8-30 I assume customs, a letter from Deutsche Post

I prefer the Buckbuster design and a thick rim as I plan on using this in 3 1/2 inch.
I am very interested in a full bore version.

I would be in for one of these slugs molds.
I am also looking for a bore rider slug mold.
Thanks

I'm in.
joharm at AOL dot com, 2-cavity HP .432 GC all pins, 32934

I think I would do a little PM on the press. First, take the bottom pin out and clean lube then drop the ram clean the ram and the cylinder, lube well. Don't forget the upper pin.

MG brass is...

Current line up:
RCBS JR3
CH Magnum
RCBS Rock Chucker
Redding Ultramag
CH Champion Heavyweight
RCBS 2A
Dillion 1050 super, NIB, Political insurance
MEC size master

Like many here I started out with a 310. It was "the" learning experience. Slow but thorough. You learn by doing and feeling the whole process. Moved on to an RCBS JR3 1974 which I still have and...

mortyg, #1 shot size, joharm at aol dot com, 32934, with handle

Thanks

Room for one more, #1 with a handle?

Hi,
Finally.
I got mine today.
Well worth the wait.

one, .432 2 cavity GC HP All pins

joharm at aol dot com

They measure the chamber with a series of gauges. You have to disassemble the bolt and trial fit the gauges. At the point that the gauge won't fit and between the previous gauge is your headspace....

I load for an M14/M1A. In an M14 a fired case cannot be used for headspace measurements. The action is such that the case is still under some internal pressure when the case is being extracted and...

Does the gun have a match chamber or a standard chamber, is it 308 or 7.62 NATO?
What is the chamber headspace?
Case headspace should be at least .003 shorter. It is my understanding that an SB...

what is an LR-308?
Is it a bolt gun or a gas gun. Reloading is different for each