Search:

BT, I think I may have missed the point about Blackmon's press possibly not using your dies. In no way am I What press would you recommend for a beginner swager without a suitable single stage press...

DukeInFlorida,
Great meeting you as well. Hopefully the show was a success. You make some fine looking bullets and I especially want to thank you for the time you spent with me talking about...

Dino,
Congratulations to your daughter. Very special memory for her.

OK this is getting weird...I was at the Jacksonville Gun Show this morning and stopped by a large table of a reloading supply/dealer to buy some powder. Off to the side was a guy who was offering...

Thanks again for all that have weighed in. BT, I have seen some of your posts regarding modifications to the Lee Classic and that may be the best way to go in the short term to learn if this swagin'...

Dang Dino. Thanks for pointing out that my location was not there; I had not noticed this. What swaging press are you using or would you recommend to a beginner? I have 2 Redding T7 turret presses...

BT and Dino, thanks for the information. BT I will be contacting you. Dino, best of luck to your daughter. Wish there was someone close by who was into swaging. I spent some time on Corbins site as...

D, good point regarding the differences about swaging "up" as opposed to drawing/swaging down. Makes sense to me from a conceptual standpoint to me the neophyte swager. Hoping others might weigh in....

uncle dino, thanks for the information. I will contact BT sniper and/or Corbins to try to get together a "starter set" to get going. I have read posts about using .380 cases as a jacket for this...

Uncle Dino, yes I have to agree with you on the 357 Maximum. This cartridge in a rifle performs well above its pay grade both in terms of accuracy and knockdown. Big hogs go down hard at reasonable...

Uncle Dino,
I just received my 357 Maximum MGM G2 barrel so your post caught my eye. Perhaps I am a bit slow but just how did you form/swage these bullets?? Thanks in advance for your reply.
Exit

So, I came upon this thread late. Is this dead or still a go for one more Johnny come lately?

exit, 1 mold, 4-cavity,GC, HP with all pins,.432,one set of handles, trigg.stephen at me dot com