Search:

I had to read the post twice just to make sure that I wasn't misreading the cost. Ouch, to say the least.

I am assuming that the bullets that you were considering were from a 7.62x54. If that is...

congrats to the winners!

#2 please

$700 really isn't all that much in the long run if you think about it. Look at how much is spent every day on "creature comforts" like cigarettes, dip, beer and cokes. Choose your vice and add it...

I vote for 4 categories, commercial, rimfire, brass case and tubing. Each type has its own pro's and con's and should be displayed individually.

In the Corbin Setup I anneal after derimming, I was popping the ends off if I annealed first. With the newest set I just got from a forum member I anneal first.

So it is really dependent on your...

There is a whole thread here on him. But I have no problems naming Colt Carpenter of Edge Dies in John Day Oregon as the person who done me wrong.

very nice, you a did good

I would agree with BTSniper on the derimming step. I have two derimmers, one from Corbins and it doesn't like being used when the case has been annealed first. The other was made by someone else,...

Blaster62
No. After going through and separating them in the manner we do, the meplats are very uniform after the pointing process.

Prospector Howard
I made the fatal mistake of trusting a...

After I posted a picture of one of my targets that I shot with rimfire bullets I have received a couple of PMs asking me how I did it. So after thinking about it all day I decided to share it with...

I use .041x.250 on all of my cleaning all polishing. They do stick in the flash holes from time to time but easy to pop out.

I used Corbin dies and "S" Press for these bullets. I still have the dies, but no longer have a press. :(

But it was the process that I learnt from a bulletsmith, Cluade, in France that made the...

Ok so after I saw this thread last night, I got stoked and after getting off of a 12 hour shift and getting some much needed shut eye I woke to perfect shooting weather. 65 degrees, no wind and...

Don't know how I missed this thread. I have a limited supply of bullets left, so sign me up.

Never mind the second one worked just fine. Thanks.

Link not working for me.

I know a few folks that use his equipment. I have spoken with him many times but as if yet I do not have any of his products.

Ring gold Georgia, you are just over the
Mountain from me.

I have used my oven to anneal many times. I usually get 95% of them done but it do 30 minutes and stir them and then another 30 minutes.

I am about three hours away to your north. What can I help you with?

Those are down right pretty. Great job.

Sounds like a broken record but like the rest I derim first then anneal. Tried it the other way and pop the top on quite a few.

Last time I stuck a bullet in the point form die I called the die maker, Corbin's. he told me to screw the die down a little at a time and keep pulling the handle. As counter to belief that my sound...

The way MI Bullet explained it is the way it warms for me. I can additional two draws to go from 35 cal to 308.