Search:

325949

go to ebay and do a search as count down timer , the one I picked up is a dial face and will count down up to 12 hrs

I use air frier basket and I also use one called Copper Crisper wich also comes with a tray wich is nice to sift the excess powder into

I second this

I have access to two presses , my buddy bought a little while back it is about 1200 at the time and I bought a fixer up one on ebay for 600 at the time when you can find a good deal once in a while ,...

for loading the brass to the 1st station if the pusher is not sending the brass all the way into the shell plate , check the ejection spring make sure it is not rubbing against the pusher bloc and...

I tried hard lubed , no go with MR bullet Feeder and thats with 45 200 swc . The closes I got it work is using a long bullet feed tube and a spring on the feeder die to retract the die , just as you...

just as Sig mention the lubed bullets tend to stick in the die . I use Mr Bullet Feeder works great with j words and pc coating , you can check them out at Double Alpha web site , they also have a...

I still have a bag of new 3 inch hulls when Ballistic Products use to sell them way back , I loaded them with steel shot

pc works fine in my mr bullet feeder

lead shot is fine over the shot cup and most 410 data uses the same wad for 2 1/2 and 3 inch hull . There is not a lot of choices when it comes to 410 wads , but company like Ballistic Products do...

the mighty die actually had left slightly more flare on the brass because I did not re adjust for each die . And note that Mighty dos put a coating on their dies and it excepts a bullet just like...

320130320131

320128320129

here are your wear patterns320126320127

well it wont be till next sat to try the marker test . I also use a marker for setting up the crimp die

I dont have Dykem , and the setup is at friends house , he hade an extra press I could experiment with , mine are tied up for now . I only go there on sat

this test was done on a 650 , and the DDA die has some use on it

I tried out the Mighty Armory yesterday , all I can say it is a lot less sticky than the DDA one , its has a touch of stick but no wear near what the DDA has . The brass was cleaned with treated...

I just ordered the Mighty Armory funnel flair die to try out for myself so I can compare it to the mr bullet feeder die

did you try the DDA one with case lube, try this test
do you have any imperial case lube if not
rub in some lube directly on the powder funnel massage it in good with finger tips just to see if it...

look into buying the Mighty Armory , I would not get the mr bullet feeder I know those stick , there is another company that sells them called Photo Escape , never delt with them . I am using...

that it looks like it was made for 38 sp wad cutter , that has a very long stem . shorten that will not help , the step to increase inside diameter is to far from the flair radius . the die should...

this is a very common issue with the mr bullet feeder die ,even worse wet tumble brass. Did you try lubed brass
There is another powder funnel die made by Mighty Armory 9mm funnel flare for...

The company that is buying Vista is not the CZ firearms which goes by CZG Group .
The company that is purchasing Vista for 1.9 billion is CSG Group and they are a munitions company and they also...