Search:

257533
New to this.....tried some silver vein from Eastwood.

What cartridge box is that? Awesome groups for 200!

Yep, life can sure take some unexpected turns. Bernie was there a couple weeks ago. And yes, they are a great group of guys to shoot with! PM sent.

Michael,
I have shot a few, around 20 or so, looking for a load for my 40-82, 14.5. twist green mountain. They shot extremely well in one of the loads! I was a little worried, however that these...

This sounds like it could be the problem. I will do some experimenting!

I meant empty the casting pot, sorry.131750131751Here are the 2 consecutive bullets I referred to above. 720 deg, using the pour method above, tried to do everything exactly the same. This doesnt...

It is a Brooks. 440 gr. 40 cal. It came with a sample bullet, and one in the cavity, which I didn't remove until just before casting. It was well packaged, and the sample must've been cast shortly...

This is a brand new mold, is there a break-in period before they start turning out consistent results? Maybe some time required to burn out all the oils and stuff in the pores of the mold? I seem to...

I marry the ladle and mold, slowly rotate 90 degrees to level, about 3 seconds to get to level. Hold the ladle in position for about 3 seconds, then pour the remainder of the ladle, (which started...

Here is a pic of good one vs bad.131686

They drop from the mold nicely, consistent weight, and surface finish is great except for one side, where all the blemishes seem to occur. Some of the bullets, right after I flux and scrape off the...

I was shooting for 20/1, had a pretty clean mix, but added some plumbers lead and a corresponding amount of tin. Boolits are sometimes dirty looking, kind of frosted in one spot(consistent location...