Search:

PM in-bound.

I'll take this, please:
10. Sierra 1971 Rifle and handgun,3rd edition rifle and handgun, 50th anniversary handgun new in wrapper, $25

PM in-bound.

Please close this thread.

Sold to Valley Forge.

Thank you, sir!

Two Lyman Cast Bullet Handbooks.
The first edition published in 1958 and the second edition published in 1973.
Both are in very good condition. For some reason the photograph will not upload, but...

PM sent.

Michael

BrassMagnet,

I have one. I will be busy till later this afternoon, so I'll send you a PM then.

Michael

Agreed, Blammer.

I wouldn't want to see the moderators use your tag line -- Sometimes you have to ignore the "good idea fairy" -- against you, though.

I have fire extinguishers at both the work bench and the casting bench.

More good news, sir.

Disassemble, thoroughly clean the threaded areas, JB Weld the two parts, let cure, reassemble.

"There is even a sticky covering it."

Been there for years, too.

I think its origins started in the Summer of '08, during the presidential campaign when Hillary and Obama were duking it out. The astute didn't need tea leaves or bones to know that a drastic change...

Char-Gar, many thanks for the information.

After a more thorough inspection, it makes more sense that the die is a taper crimp die, opposed to a seating die.

To answer your question: No, the...

I have one that is its twin, but without any kind of markings. It was in a box of used Hornady .45 ACP dies, and I figured that it was a home made seating die. Measured with an inside micrometer,...

I can understand their stances on not becoming involved with the selling and the transfer of monies on the sale of ATF required serial numbered items, or others that may be illegal in certain states...

Instead of whacking the sprue cutter, use your gloved hand (thumb). You mould will thank you. (Forget macho, be smart, wear gloves. Experience says that molten lead alloy burns go deep, hurt, and...

Other than the standard cleaning, I've found that my iron moulds -- Ideal, Lyman, and RCBS -- have never required all the end-user quality control measures and finessing that is typical of Lee...

I bought two in '05, the first one was priced at $99 and the second was $79.

Replace the O-rings.

That's it.

"Others deprime/size, prime, then tumble"

It may not matter, but why take the chance of media getting stuck in the flash hole?

If you deprime then tumble, make sure to clean the flash hole and...

Pictures three and four are of a Lyman sizing (H&I) die. Don't know about the others.

Welcome home and a snappy salute to your son and his unit.

The third edition's metallurgy chapter is much easier to read and comprehend. It, too, was written by a metallurgist but with verbiage and a style that doesn't require a doctorate degree to decipher...