Hmm, I would think unless they read the packing slip, probably not. I don't think most people could identify a bullet mold packed like that, although they certainly could if it wasn't wrapped.
Printable View
Got my Penta Pins. Thanks Miha! The machining is even better than the first group buy.
Were there any extras on this run?
He will post after he gives the slow pay(didn’t check email) guys to see if they claim theirs. Then he posts what’s left. After us he posts to his website. I’m waiting for one as well. What do you want?
I'm probably a buyer on a .432 gas check 2 boolit hollow point mold if there are extras. I just casted with devastator mold number 5 and it still leaks around the hp area. This mold must cast a little smaller, my devastator casts around 263 to 265gr.
I will post a list shortly
Hi,
Finally.
I got mine today.
Well worth the wait.
Checking back, were there any extras of this mold? I am not seeing any on the MP site.
If you’re ready to get two solid molds I’m going to run this as a solid only soon. Either here or on the Marlin Shooters site. Need 6 more cause I’m getting two.
http://castboolits.gunloads.com/show...98#post4487798
I run rcbs 429421 for my solids but really like the profile and case capacity this offered. Really wanted a hp .44
I never got a PayPal invoice on this one.
Sent from my SM-G930P using Tapatalk
His website says he still has some. Here is the 432 HP 4 cavity https://www.mp-molds.com/e-shop/mold...56-pb-hp-4-cav
He has only 432-256 (H&G #503 clone), 432-244 and 434-215 visible on his e-shop, but for sure he has some 432-640 Devastator and 432-423 + some new 44 Hammers (?) on his shelves. I would write him directly and ask. This was how I got my Devastator.
Attachment 230433
H&G#503 clone on left, 432-640 on R
https://uploads.tapatalk-cdn.com/201...f087aba29a.jpg
Your photos are always so nice. Truly an asset to the forum. I followed up with him and he doesn't have many options remaining in this mold. I have asked that he keep this one in stock as this is undoubtedly his most sought after mold.
I'm going to ask him if he will authorize a short run to coincide with an inventory run. 10 HP molds to cut molds.
Bluejay