Sharp as needle..High BC:s, but would it be possible to have them for the .338:s..
If there is enough interested people, maybe Swede will press the go- button for it.
http://i459.photobucket.com/albums/q...tos/339365.jpg
S
Hope this photo works.
Printable View
Sharp as needle..High BC:s, but would it be possible to have them for the .338:s..
If there is enough interested people, maybe Swede will press the go- button for it.
http://i459.photobucket.com/albums/q...tos/339365.jpg
S
Hope this photo works.
Am I the only one having trouble opening the link to Photobucket? Seppos - You thinking something in the 250-260 grain range? If Swede would do something like he did for the 358318 RNGC GB where you could get one cavity HP'd and the HP pin puts a flat point or a HP on the boolet, Hmmmm..... very interesting.
JK
Couldn`t get photobucket to open either. The idea of the mold is interesting though.Robert
Surprised there isn't more interest in this one. Nice practice/plinker for the 338 Edge and Lapuas.
Bump to the top.
Jeff
I´m interested! Need such a mold for my 338Lapua[smilie=w:.
Back up on top.
This one must be of interest to more people!...?
250-300grainer would be fine. Byt i'd like the boolit as pointy as possible...maybe a 300grainer would need a blunt nose to be short enough to fred through My rifles magazine. I'd probably use it as singleshot repeater anyhow...hmm
Sent from my iPhone using Tapatalk
I'd even entertain the idea of a boolit heavier than 300 grains We might be giving-up some velocity anyway, to keep the leading controlled, longer boolit means higher BC (all else being equal, of course)
Maybe a sharp point and 325-to-350 grains?
I'd be in for a 300 grain (or so) sharp.....:wink:
I'd like to have one also, sharp point at least 250 gr.
Frank
Bump for interest....;- )
I would be interested.
Aaron
339365 in a 300gr would be just fine. Pencil me in if y'all would.
Rich
Yep, thats the one :drinks:
OK, I'm firmly commited to a 2-or-3 cavity of the "340302". And I'd pop the extra $10 for the small order, if required.
Ok, i'll bite.
A 3 or 4 holer +$10 is fine with me if the boreriding part is snug enough for my barrel...need to slug it.
---
I am here: http://maps.google.com/maps?ll=59.065212,15.348860
Sent from my iPhone using Tapatalk
I'm ok with an extra $10.....:Fire: Count me in!
I would like a 4-cavity.
SCB were you thinking of any particular cartridge with this in mind..? Seems the .338 Spectre would benefit from it, especially if its basically a scaled up and sharpened up 311247...
A flatnose pin or some easy way to flatten would be nice, but considering the cost of .338 j-words, anything is an improvement :-)
I'm definitely interested.
SC