Originally Posted by
44magLeo
I have a steel set of handles that are marked 30-06. The hole in the handle where the case goes into is way larger than a 30-06 case is.
The hole measures .560 or so with my calipers. A bit bigger than the .473 I get on a 30-06 case.
I was thinking, would it be possible for some with a lathe to ream this hole large enough to cut threads the rest of the way through the handle?
Once the hole was threaded could they could counter sink the hole so you could thread in the adapter die? While doing all this you would need to counter sink the hole for the locking screw of course.
If so, how much do you think it might cost?
I have this set of handles in the 310 swap thread, no takers as of yet.
Leo