could you put me down for a set of handles too?
could you put me down for a set of handles too?
Yes Sir, I've added handles for you!Quote:
Originally Posted by mto7464
Mornin Buddy
Throw me in on this one please
Max at yvmarine dot com 8 Cav 147 bb lube groove
Thanks Max, I've got you on the list! :)Quote:
Originally Posted by Wasalmonslayer
6 cav, NLG, 358, flat base
Davidcates408 at gmail dot com
Sent from my iPhone using Tapatalk
Ive got you on the list, thankyou!Quote:
Originally Posted by davek8s
1 more order and this one goes to active!
Sent from my SM-G920V using Tapatalk
Might as well....looks like a good design....
8 cavity aluminum, .358, Bevel Base
ALBROOMS at comcast DOT net
Got you on, now we go active, thanks!!Quote:
Originally Posted by Broomstraw
Sent from my SM-G920V using Tapatalk
2x 8cavity smooth side bevel base .358 plz - dwyer11c(at)hotmail(dot)com
Miha will only be shipping via DHL from now on and i think no more invoicing, rather youll be notified the order is ready and you purchase (similar pay methods) on his website.
This is going to be a HUGE time saver for everyone.
Sent from my SM-G920V using Tapatalk
Thanks Sir, ive got you down for 2 molds.Quote:
Originally Posted by Canadachris
Sent from my SM-G920V using Tapatalk
Hey, was wondering if MP molds will honour the same price as their website. Same mold €76. I know its out of stock, but it would be nice to get that deal.
Regards.
Hey,
76 doesn't include shipping if you order from his site so 80.75 euros is actually less considering DHL shipping is now included.
Sent from my SM-G920V using Tapatalk
I have to back out.Quote:
Originally Posted by davek8s
Sent from my iPhone using Tapatalk
Ive removed you from the list.Quote:
Originally Posted by davek8s
Sent from my SM-G920V using Tapatalk
A silly question: if you use this boolit design in revolver rounds, where do you crimp?
Brewer, the intent for this bullet in revolver is light loads for PPC and in that case, you would only touch, with your roll die. I use a taper crimp just to flush up.Quote:
Originally Posted by brewer12345
Alternatively, if your brand revolver has cylinder length, you could load long and crimp at the front of lube groove. You would need to do a bunch of measurements and pressures to determine what works, but its possible to do.
Sent from my SM-G920V using Tapatalk
Please remove me from this buy going with another 9mm GB.
No problem mto I've got you updatedQuote:
Originally Posted by mto7464
Both of these are available on Miha's new WEB site. This mold looks good. Please remove me from this group buy. Gonna purchase direct. Thanks!
ALBROOMS #6 on the 8 cav with lube groove