Printable View
I got a few Dan Wesson parts in a trade a while back and if you can USE THEM (not sell them) let me know. They are as follows-
side plate screw short SS
side plate screw long SS
firing/trigger rear sight pin SS (I don't know?? That's what the pack says)
spring bolt SS
Bolt plunger SS
Still in the Brownells bags. If you need one of the parts let me know. Neil
Thanks moderator I didn't know this board existed.
I can use them. PM sent.
probably dont know the caliber and it probably doesnt matter for those parts but if they would work on a 357 mag, i could use some extra parts for just in case but if somebody needs them right now for a project i can get by.
Very generous of you northwoodsneil.
I saw your post in the gunsmithing section, then found this one here.
I'm just getting into tinkering on the (2) DW handguns I have,, and was a bit interested. But they are already spoken for,, and they are also stainless parts, so I just thought I'd say; "Good job" on how you handled it.
My DW handguns are both blued guns anyway! :D :D
I'll see what M-tecs needs and if there's anything left I'll repost it. Neil
The parts are gone gents.