I use the Lee 125gr and the 158 gr flat nose in 4 different revolvers and while the 125gr is fine for practice and plinkin', I would give the nod to the 158 gr for accuracy in front of a near max charge of win 296. But that is in "MY" guns.
Printable View
I use the Lee 125gr and the 158 gr flat nose in 4 different revolvers and while the 125gr is fine for practice and plinkin', I would give the nod to the 158 gr for accuracy in front of a near max charge of win 296. But that is in "MY" guns.
With accuracy in the 900-1000fps range you will be hard pressed to beat the Lee 125RF with Bullseye or 231 in the 4-5 gr range.
The Noe 358-124 gr.-TC , GC , has shown itself to be very accurate in my 357 magnum Ruger Blackhawk.
This bullet sized .358 with a gas check and a load with AA#5 put 15 shots into one ragged hole that spanned 1 3/8 " with no pesky flyers. Even when cast 50/50 WW and lead the gas check allows it to be driven at magnum velocities with no leading . Also had good accuracy with 38 special +P loads.
This bullet is showing a lot of promise in the 38 spcl , 357 mag. and 9 mm.
Gary
I was using Lyman 357466 2 cavity until recently when I picked up Lee 357-158-RF. I really like that Lee 357-158-RF and even though I have some more accuracy testing to so far i think its going to be a winner. Lyman 358466 is dropping small but after PC i got it sized to .3575 which is what i use for my GP100 and my 9mm p320. There are many posts about Lyman dropping small and people dropping Lyman in response i guess. I only have 2 lyman 2 cavity molds but I think I'm going to sell those since I'm not planning on using those much now.
The MP 359640 (150 gr HP) is a wonderful design. I shoot that one as my practice round in Rossi 92 an 686.
I shot 10 mouse fart rds. today out of my new Henry. These were sized to .359 and just barely fit in my SW 27. Well, I got leading just ahead of the rifle's chamber. Makes me wonder if the throat is over size? You think a gas check type mold might be the way to go? It was a Lee TL type swc 158 gr. over 4.8 of tight group.
I can surmise that the Henry won't be able to share cast loads with my 27 since it won't chamber a .360 boolit.
Could be the Henry will have to be a jacketed boolit gun.
Update - I guess the Henry prefers boolits sized to .358. Shot a bunch recently of that size without appreciable leading. Also shot some 165 gr. pc over 14 gr. of 2400 and they worked great.