Printable View
Howdy all. Long time lurker. I’ve been here since 2012. Y’all are a great wealth of knowledge. I’ve got an issue. I’ve got 4,000 to 5,000 cast .40 caliber bullets I’ll never use. Most are from Missouri bullet co. I’d like to swags them down to .357 so I could use them in my .35 whelen. Is that possible? I see data for the weight but I’ve never swaged down anything.
Thanks for your help.
Gary
It would be cheaper to recast them than to obtain the equipment and swage them. For the cost of the dies alone you could buy all the casting equipment.
What he said................Quote:
Originally Posted by Sasquatch-1
Actually you wouldn't have to swage them down to .357. The groove size of that 35 Whelen should be .358. I have a Whelen and that is my groove. The bullet I cast for it drops from the mould at .359 so that's what I shoot it at. You can swage them to the fattest diameter that will chamber. So now it appears you may not have to swage them down so far. One note, make sure the lube grooves on the bullets are full or you will lose the groove when swaging them down. You will lose only a little bit of the grooves if they are full. Good luck!
Swaging makes things bigger, drawing is the process of making things smaller.
Sell them in the Swappin and Selling section and buy some bullets the right size.
Yes you are very correct. I was thinking in reverse. He would have to have special sizer die to do that , one that began with a long taper down to the final size. Best to sell them or melt them and get the correct bullet mold. There is a very good mould for that caliber on Mihec's sight. He's the mould maker in Slovakia. It comes with pins to make a hollow point or solid. I have it and my Whelen shoots 1/2 inch groups with it at 100 yards. I'm using Unique so it's not a full power load, about like a 35 Remington. Plenty good enough for deer hunting.Quote:
Originally Posted by deltaenterprizes
I was going to suggest he sell them but then I notice he only had one post on the forum.Quote:
Originally Posted by deltaenterprizes
More than 10 or 12 thousandths tends to be a big pain. Easier IMO to make things bigger, smaller is hard.
Either melt them and recast in a .357mag mold. Or sell and trade for some good .357 pills.